[exit]
-CONFIG = $DEFAULTCONFIG
BINARY = gnunet-daemon-exit
-IPV6ADDR = 1234:1::1
-IPV6PREFIX = 32
-IPV4ADDR = 10.10.1.1
-IPV4MASK = 255.255.0.0
-IFNAME = exit-gnunet
-ENABLE_UDP = NO
-ENABLE_TCP = NO
-
-# MAX_CONNECTIONS = 256
+
+# IPv6 address for the TUN interface (must be changed as this
+# must be within the global IPv6 range of your system!)
+IPV6ADDR = 2001:DB8::1
+
+# Prefix for our IPv6 subnet on the TUN interface.
+IPV6PREFIX = 64
+
+# IPv4 address to use on our TUN interface (may need to be
+# changed to avoid conflicts with existing addresses on your system).
+# Use RFC 3927-style link-local address
+IPV4ADDR = 169.254.86.1
+
+# Netmask for the IPv4 subnet on the TUN interface.
+IPV4MASK = 255.255.255.0
+
+# IPv4 networks to which we are allowed to exit.
+# The format is "(network[/netmask][:[!]SPORT-DPORT];)*"
+EXIT_RANGE_IPV4_POLICY = 0.0.0.0/0:!25;
+
+# IPv6 networks to which we are allowed to exit.
+# The format is "(network[/netmask][:[!]SPORT-DPORT];)*"
+EXIT_RANGE_IPV6_POLICY = ::/0:!25;
+
+
+# Name of the (virtual) tunnel interface the exit daemon will manage
+TUN_IFNAME = exit-gnunet
+
+# Name of the "real" interface that IPv4 traffic from this system will
+# leave from; this is the name of the interface where we need to
+# enable NAT on postrouting (typically something like 'eth0' or 'eth1'
+# or 'wlan0'). Not needed if EXIT_IPv4 is disabled AND if all
+# offered services run on 'localhost'. In this case, the value
+# of the option can instead be set to "%" (to not enable NAT on any
+# interface).
+EXIT_IFNAME = eth0
+
+# Set this to YES to allow exiting this system via IPv4 to the Internet
+EXIT_IPV4 = NO
+
+# Set this to YES to allow exiting this system via IPv6 to the Internet
+EXIT_IPV6 = NO
+
+# This option should be set to YES to allow the DNS service to
+# perform lookups against the locally configured DNS resolver.
+# (set to "NO" if no normal ISP is locally available and thus
+# requests for normal ".com"/".org"/etc. must be routed via
+# the GNUnet VPN (the GNUNET PT daemon then needs to be configured
+# to intercept and route DNS queries via cadet).
+# Set this to YES to allow using this system for DNS queries.
+EXIT_DNS = NO
+
+# Set this to an IPv4 or IPv6 address of a DNS resolver to use for DNS queries
+DNS_RESOLVER = 8.8.8.8
+
+# For IPv4-services offered by this peer, we need to at least enable IPv4
+ENABLE_IPV4 = YES
+
+# For IPv6-services offered by this peer, we need to at least enable IPv6
+ENABLE_IPV6 = YES
+
+
+# Maximum number of concurrent connections this exit supports.
+MAX_CONNECTIONS = 256