# IPv6 address for the TUN interface (must be changed as this
# must be within the global IPv6 range of your system!)
-IPV6ADDR = 1234:1::1
+IPV6ADDR = 2001:DB8::1
# Prefix for our IPv6 subnet on the TUN interface.
-IPV6PREFIX = 32
+IPV6PREFIX = 64
# IPv4 address to use on our TUN interface (may need to be
# changed to avoid conflicts with existing addresses on your system).
-IPV4ADDR = 10.10.1.1
+# Use RFC 3927-style link-local address
+IPV4ADDR = 169.254.86.1
# Netmask for the IPv4 subnet on the TUN interface.
-IPV4MASK = 255.255.0.0
+IPV4MASK = 255.255.255.0
# Name of the (virtual) tunnel interface the exit daemon will manage
# Name of the "real" interface that IPv4 traffic from this system will
# leave from; this is the name of the interface where we need to
# enable NAT on postrouting (typically something like 'eth0' or 'eth1'
-# or 'wlan0'). Not needed if EXIT_IPv4 is disabled.
+# or 'wlan0'). Not needed if EXIT_IPv4 is disabled AND if all
+# offered services run on 'localhost'. In this case, the value
+# of the option can instead be set to "%" (to not enable NAT on any
+# interface).
EXIT_IFNAME = eth0
# Set this to YES to allow exiting this system via IPv4 to the Internet
EXIT_IPV6 = NO
# For IPv4-services offered by this peer, we need to at least enable IPv4
-ENABLE_IPV4 = NO
+ENABLE_IPV4 = YES
# For IPv6-services offered by this peer, we need to at least enable IPv6
-ENABLE_IPV6 = NO
+ENABLE_IPV6 = YES
# Maximum number of concurrent connections this exit supports.