1 .TH GNUNET\-TESTBED\-PROFILER 1 "September 13, 2014" "GNUnet"
3 gnunet\-testbed\-profiler \- Profiling driver for the testbed.
5 .B gnunet\-testbed\-profiler
9 \fBgnunet\-testbed\-profiler\fP is a command line profiling driver for the testbed.
12 .IP "\-c FILENAME, \-\-config=FILENAME"
13 Use the configuration file FILENAME.
15 .IP "\-e COUNT, \-\-num\-errors=COUNT"
16 Tolerate COUNT number of continious timeout failures.
18 .IP "\-H FILENAME, \-\-hosts=FILENAME"
19 Name of the file with the login information for the testbed.
22 Print short help on options.
24 .IP "\-L LOGLEVEL, \-\-loglevel=LOGLEVEL"
25 Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
27 .IP "\-l LOGFILE, \-\-logfile=LOGFILE"
28 Configure logging to write logs to LOGFILE.
30 .IP "\-n, \-\-non\-interactive"
31 Run profiler in non-interactive mode where upon testbed setup the
32 profiler does not wait for a keystroke but continues to run until a
33 termination signal is received.
35 .IP "\-p COUNT, \-\-num\-peers=COUNT"
36 Create COUNT number of peers.
38 .IP "\-v, \-\-version"
39 Print GNUnet version number.
41 Report bugs by using Mantis <https://bugs.gnunet.org/> or by sending electronic mail to <gnunet\-developers@gnu.org>
43 The full documentation for
45 is maintained as a Texinfo manual. If the
49 programs are properly installed at your site, the command
53 should give you access to the complete handbook,
55 .B info gnunet-c-tutorial
57 will give you access to a tutorial for developers.
59 Depending on your installation, this information is also
61 \fBgnunet\fP(7) and \fBgnunet-c-tutorial\fP(7).