mmc: sdhci: Use debug for not supported SDMA info message

If CONFIG_MMC_SDHCI_SDMA is enabled but the HW could not support it,
we no longer error out. Instead we do not enable it in the host.
Change the output from printf to debug as this isn't an error but only
additional information now.

Signed-off-by: Matthias Brugger <mbrugger@suse.com>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Matthias Brugger <mbrugger@suse.com>

diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
index 6e8f6e3d179ff13cb7a4ada8056e0be805555fa8..8bb4393ce19a16ab8d9e249afc04fcdac445db17 100644 (file)
--- a/drivers/mmc/sdhci.c
+++ b/drivers/mmc/sdhci.c
@@ -744,8 +744,8 @@ int sdhci_setup_cfg(struct mmc_config *cfg, struct sdhci_host *host,
        if ((caps & SDHCI_CAN_DO_SDMA)) {
                host->flags |= USE_SDMA;
        } else {
-               printf("%s: Your controller doesn't support SDMA!!\n",
-                      __func__);
+               debug("%s: Your controller doesn't support SDMA!!\n",
+                     __func__);
        }
 #endif
 #if CONFIG_IS_ENABLED(MMC_SDHCI_ADMA)