#include <linux/mbus.h>
#include <asm-generic/gpio.h>
#include <fdt_support.h>
+#include <linux/mdio.h>
DECLARE_GLOBAL_DATA_PTR;
#define MTU 1500
#define RX_BUFFER_SIZE (ALIGN(MTU + WRAP, ARCH_DMA_MINALIGN))
-#define MVPP2_SMI_TIMEOUT 10000
-
/* RX Fifo Registers */
#define MVPP2_RX_DATA_FIFO_SIZE_REG(port) (0x00 + 4 * (port))
#define MVPP2_RX_ATTR_FIFO_SIZE_REG(port) (0x20 + 4 * (port))
#define MVPP2_QUEUE_NEXT_DESC(q, index) \
(((index) < (q)->last_desc) ? ((index) + 1) : 0)
-/* SMI: 0xc0054 -> offset 0x54 to lms_base */
-#define MVPP21_SMI 0x0054
/* PP2.2: SMI: 0x12a200 -> offset 0x1200 to iface_base */
#define MVPP22_SMI 0x1200
-#define MVPP2_PHY_REG_MASK 0x1f
-/* SMI register fields */
-#define MVPP2_SMI_DATA_OFFS 0 /* Data */
-#define MVPP2_SMI_DATA_MASK (0xffff << MVPP2_SMI_DATA_OFFS)
-#define MVPP2_SMI_DEV_ADDR_OFFS 16 /* PHY device address */
-#define MVPP2_SMI_REG_ADDR_OFFS 21 /* PHY device reg addr*/
-#define MVPP2_SMI_OPCODE_OFFS 26 /* Write/Read opcode */
-#define MVPP2_SMI_OPCODE_READ (1 << MVPP2_SMI_OPCODE_OFFS)
-#define MVPP2_SMI_READ_VALID (1 << 27) /* Read Valid */
-#define MVPP2_SMI_BUSY (1 << 28) /* Busy */
-
-#define MVPP2_PHY_ADDR_MASK 0x1f
-#define MVPP2_PHY_REG_MASK 0x1f
/* Additional PPv2.2 offsets */
#define MVPP22_MPCS 0x007000
/* Per-port registers' base address */
void __iomem *base;
- void __iomem *mdio_base;
struct mvpp2_rx_queue **rxqs;
struct mvpp2_tx_queue **txqs;
struct phy_device *phy_dev;
phy_interface_t phy_interface;
- int phy_node;
int phyaddr;
- struct mii_dev *bus;
+ struct udevice *mdio_dev;
#ifdef CONFIG_DM_GPIO
struct gpio_desc phy_reset_gpio;
struct gpio_desc phy_tx_disable_gpio;
struct phy_device *phy_dev;
if (!port->init || port->link == 0) {
- phy_dev = phy_connect(port->bus, port->phyaddr, dev,
- port->phy_interface);
+ phy_dev = dm_mdio_phy_connect(port->mdio_dev, port->phyaddr,
+ dev, port->phy_interface);
/*
* If the phy doesn't match with any existing u-boot drivers the
return err;
}
- if (port->phy_node) {
+ if (port->phyaddr < PHY_MAX_ADDR) {
mvpp2_phy_connect(dev, port);
mvpp2_link_event(port);
} else {
u32 id;
u32 phyaddr = 0;
int phy_mode = -1;
-
- /* Default mdio_base from the same eth base */
- if (port->priv->hw_version == MVPP21)
- port->mdio_base = port->priv->lms_base + MVPP21_SMI;
- else
- port->mdio_base = port->priv->iface_base + MVPP22_SMI;
+ int ret;
phy_node = fdtdec_lookup_phandle(gd->fdt_blob, port_node, "phy");
if (phy_node > 0) {
- ofnode phy_ofnode;
- fdt_addr_t phy_base;
-
+ int parent;
phyaddr = fdtdec_get_int(gd->fdt_blob, phy_node, "reg", 0);
if (phyaddr < 0) {
dev_err(&pdev->dev, "could not find phy address\n");
return -1;
}
-
- phy_ofnode = ofnode_get_parent(offset_to_ofnode(phy_node));
- phy_base = ofnode_get_addr(phy_ofnode);
- port->mdio_base = (void *)phy_base;
-
- if (port->mdio_base < 0) {
- dev_err(&pdev->dev, "could not find mdio base address\n");
- return -1;
- }
+ parent = fdt_parent_offset(gd->fdt_blob, phy_node);
+ ret = uclass_get_device_by_of_offset(UCLASS_MDIO, parent,
+ &port->mdio_dev);
+ if (ret)
+ return ret;
} else {
- phy_node = 0;
+ /* phy_addr is set to invalid value */
+ phyaddr = PHY_MAX_ADDR;
}
phy_mode_str = fdt_getprop(gd->fdt_blob, port_node, "phy-mode", NULL);
port->first_rxq = port->id * rxq_number;
else
port->first_rxq = port->id * port->priv->max_port_rxqs;
- port->phy_node = phy_node;
port->phy_interface = phy_mode;
port->phyaddr = phyaddr;
return 0;
}
-/* SMI / MDIO functions */
-
-static int smi_wait_ready(struct mvpp2_port *priv)
-{
- u32 timeout = MVPP2_SMI_TIMEOUT;
- u32 smi_reg;
-
- /* wait till the SMI is not busy */
- do {
- /* read smi register */
- smi_reg = readl(priv->mdio_base);
- if (timeout-- == 0) {
- printf("Error: SMI busy timeout\n");
- return -EFAULT;
- }
- } while (smi_reg & MVPP2_SMI_BUSY);
-
- return 0;
-}
-
-/*
- * mpp2_mdio_read - miiphy_read callback function.
- *
- * Returns 16bit phy register value, or 0xffff on error
- */
-static int mpp2_mdio_read(struct mii_dev *bus, int addr, int devad, int reg)
-{
- struct mvpp2_port *priv = bus->priv;
- u32 smi_reg;
- u32 timeout;
-
- /* check parameters */
- if (addr > MVPP2_PHY_ADDR_MASK) {
- printf("Error: Invalid PHY address %d\n", addr);
- return -EFAULT;
- }
-
- if (reg > MVPP2_PHY_REG_MASK) {
- printf("Err: Invalid register offset %d\n", reg);
- return -EFAULT;
- }
-
- /* wait till the SMI is not busy */
- if (smi_wait_ready(priv) < 0)
- return -EFAULT;
-
- /* fill the phy address and regiser offset and read opcode */
- smi_reg = (addr << MVPP2_SMI_DEV_ADDR_OFFS)
- | (reg << MVPP2_SMI_REG_ADDR_OFFS)
- | MVPP2_SMI_OPCODE_READ;
-
- /* write the smi register */
- writel(smi_reg, priv->mdio_base);
-
- /* wait till read value is ready */
- timeout = MVPP2_SMI_TIMEOUT;
-
- do {
- /* read smi register */
- smi_reg = readl(priv->mdio_base);
- if (timeout-- == 0) {
- printf("Err: SMI read ready timeout\n");
- return -EFAULT;
- }
- } while (!(smi_reg & MVPP2_SMI_READ_VALID));
-
- /* Wait for the data to update in the SMI register */
- for (timeout = 0; timeout < MVPP2_SMI_TIMEOUT; timeout++)
- ;
-
- return readl(priv->mdio_base) & MVPP2_SMI_DATA_MASK;
-}
-
-/*
- * mpp2_mdio_write - miiphy_write callback function.
- *
- * Returns 0 if write succeed, -EINVAL on bad parameters
- * -ETIME on timeout
- */
-static int mpp2_mdio_write(struct mii_dev *bus, int addr, int devad, int reg,
- u16 value)
-{
- struct mvpp2_port *priv = bus->priv;
- u32 smi_reg;
-
- /* check parameters */
- if (addr > MVPP2_PHY_ADDR_MASK) {
- printf("Error: Invalid PHY address %d\n", addr);
- return -EFAULT;
- }
-
- if (reg > MVPP2_PHY_REG_MASK) {
- printf("Err: Invalid register offset %d\n", reg);
- return -EFAULT;
- }
-
- /* wait till the SMI is not busy */
- if (smi_wait_ready(priv) < 0)
- return -EFAULT;
-
- /* fill the phy addr and reg offset and write opcode and data */
- smi_reg = value << MVPP2_SMI_DATA_OFFS;
- smi_reg |= (addr << MVPP2_SMI_DEV_ADDR_OFFS)
- | (reg << MVPP2_SMI_REG_ADDR_OFFS);
- smi_reg &= ~MVPP2_SMI_OPCODE_READ;
-
- /* write the smi register */
- writel(smi_reg, priv->mdio_base);
-
- return 0;
-}
-
static int mvpp2_recv(struct udevice *dev, int flags, uchar **packetp)
{
struct mvpp2_port *port = dev_get_priv(dev);
struct mvpp2_rx_queue *rxq;
u8 *data;
- if (port->phy_node)
+ if (port->phyaddr < PHY_MAX_ADDR)
if (!port->phy_dev->link)
return 0;
int tx_done;
int timeout;
- if (port->phy_node)
+ if (port->phyaddr < PHY_MAX_ADDR)
if (!port->phy_dev->link)
return 0;
{
struct mvpp2_port *port = dev_get_priv(dev);
struct mvpp2 *priv = dev_get_priv(dev->parent);
- struct mii_dev *bus;
int err;
/* Only call the probe function for the parent once */
if (!priv->probe_done)
err = mvpp2_base_probe(dev->parent);
- port->priv = dev_get_priv(dev->parent);
-
- /* Create and register the MDIO bus driver */
- bus = mdio_alloc();
- if (!bus) {
- printf("Failed to allocate MDIO bus\n");
- return -ENOMEM;
- }
-
- bus->read = mpp2_mdio_read;
- bus->write = mpp2_mdio_write;
- snprintf(bus->name, sizeof(bus->name), dev->name);
- bus->priv = (void *)port;
- port->bus = bus;
-
- err = mdio_register(bus);
- if (err)
- return err;
+ port->priv = priv;
err = phy_info_parse(dev, port);
if (err)
port->gop_id * MVPP22_PORT_OFFSET;
/* Set phy address of the port */
- if(port->phy_node)
+ if (port->phyaddr < PHY_MAX_ADDR)
mvpp22_smi_phy_addr_cfg(port);
/* GoP Init */
projects / oweals / u-boot.git / commitdiff