powerpc, 8xx: remove support for 8xx
[oweals/u-boot.git] / include / status_led.h
1 /*
2  * (C) Copyright 2000-2004
3  * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
4  *
5  * SPDX-License-Identifier:     GPL-2.0+
6  */
7
8 /*
9  * The purpose of this code is to signal the operational status of a
10  * target which usually boots over the network; while running in
11  * PCBoot, a status LED is blinking. As soon as a valid BOOTP reply
12  * message has been received, the LED is turned off. The Linux
13  * kernel, once it is running, will start blinking the LED again,
14  * with another frequency.
15  */
16
17 #ifndef _STATUS_LED_H_
18 #define _STATUS_LED_H_
19
20 #ifdef CONFIG_LED_STATUS
21
22 #define LED_STATUS_PERIOD       (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ)
23 #ifdef CONFIG_LED_STATUS1
24 #define LED_STATUS_PERIOD1      (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ1)
25 #endif /* CONFIG_LED_STATUS1 */
26 #ifdef CONFIG_LED_STATUS2
27 #define LED_STATUS_PERIOD2      (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ2)
28 #endif /* CONFIG_LED_STATUS2 */
29 #ifdef CONFIG_LED_STATUS3
30 #define LED_STATUS_PERIOD3      (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ3)
31 #endif /* CONFIG_LED_STATUS3 */
32 #ifdef CONFIG_LED_STATUS4
33 #define LED_STATUS_PERIOD4      (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ4)
34 #endif /* CONFIG_LED_STATUS4 */
35 #ifdef CONFIG_LED_STATUS5
36 #define LED_STATUS_PERIOD5      (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ5)
37 #endif /* CONFIG_LED_STATUS5 */
38
39 void status_led_init(void);
40 void status_led_tick (unsigned long timestamp);
41 void status_led_set  (int led, int state);
42
43 /*****  MVS v1  **********************************************************/
44 #if (defined(CONFIG_MVS) && CONFIG_MVS < 2)
45 # define STATUS_LED_PAR         im_ioport.iop_pdpar
46 # define STATUS_LED_DIR         im_ioport.iop_pddir
47 # undef  STATUS_LED_ODR
48 # define STATUS_LED_DAT         im_ioport.iop_pddat
49
50 # define STATUS_LED_ACTIVE      1               /* LED on for bit == 1  */
51
52 /*****  Someone else defines these  *************************************/
53 #elif defined(STATUS_LED_PAR)
54   /*
55    * ADVICE: Define in your board configuration file rather than
56    * filling this file up with lots of custom board stuff.
57    */
58
59 #elif defined(CONFIG_V38B)
60
61 # define STATUS_LED_ACTIVE      0               /* LED on for bit == 0 */
62
63 #elif defined(CONFIG_LED_STATUS_BOARD_SPECIFIC)
64 /* led_id_t is unsigned long mask */
65 typedef unsigned long led_id_t;
66
67 extern void __led_toggle (led_id_t mask);
68 extern void __led_init (led_id_t mask, int state);
69 extern void __led_set (led_id_t mask, int state);
70 void __led_blink(led_id_t mask, int freq);
71 #else
72 # error Status LED configuration missing
73 #endif
74 /************************************************************************/
75
76 #ifndef CONFIG_LED_STATUS_BOARD_SPECIFIC
77 # include <asm/status_led.h>
78 #endif
79
80 #endif  /* CONFIG_LED_STATUS    */
81
82 /*
83  * Coloured LEDs API
84  */
85 #ifndef __ASSEMBLY__
86 void coloured_LED_init(void);
87 void red_led_on(void);
88 void red_led_off(void);
89 void green_led_on(void);
90 void green_led_off(void);
91 void yellow_led_on(void);
92 void yellow_led_off(void);
93 void blue_led_on(void);
94 void blue_led_off(void);
95 #else
96         .extern LED_init
97         .extern red_led_on
98         .extern red_led_off
99         .extern yellow_led_on
100         .extern yellow_led_off
101         .extern green_led_on
102         .extern green_led_off
103         .extern blue_led_on
104         .extern blue_led_off
105 #endif
106
107 #endif  /* _STATUS_LED_H_       */