include/configs/devkit3250.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Embest/Timll DevKit3250 board configuration file
   4  *
   5  * Copyright (C) 2011-2015 Vladimir Zapolskiy <vz@mleia.com>
   6  */
   7
   8 #ifndef __CONFIG_DEVKIT3250_H__
   9 #define __CONFIG_DEVKIT3250_H__
  10
  11 /* SoC and board defines */
  12 #include <linux/sizes.h>
  13 #include <asm/arch/cpu.h>
  14
  15 #define CONFIG_MACH_TYPE                MACH_TYPE_DEVKIT3250
  16
  17 #define CONFIG_SYS_ICACHE_OFF
  18 #define CONFIG_SYS_DCACHE_OFF
  19 #if !defined(CONFIG_SPL_BUILD)
  20 #define CONFIG_SKIP_LOWLEVEL_INIT
  21 #endif
  22
  23 /*
  24  * Memory configurations
  25  */
  26 #define CONFIG_SYS_MALLOC_LEN           SZ_1M
  27 #define CONFIG_SYS_SDRAM_BASE           EMC_DYCS0_BASE
  28 #define CONFIG_SYS_SDRAM_SIZE           SZ_64M
  29 #define CONFIG_SYS_MEMTEST_START        (CONFIG_SYS_SDRAM_BASE + SZ_32K)
  30 #define CONFIG_SYS_MEMTEST_END          (CONFIG_SYS_TEXT_BASE - SZ_1M)
  31
  32 #define CONFIG_SYS_LOAD_ADDR            (CONFIG_SYS_SDRAM_BASE + SZ_32K)
  33
  34 #define CONFIG_SYS_INIT_SP_ADDR         (CONFIG_SYS_SDRAM_BASE + SZ_4K \
  35                                          - GENERATED_GBL_DATA_SIZE)
  36
  37 /*
  38  * Serial Driver
  39  */
  40 #define CONFIG_SYS_LPC32XX_UART         5   /* UART5 */
  41
  42 /*
  43  * DMA
  44  */
  45 #if !defined(CONFIG_SPL_BUILD)
  46 #define CONFIG_DMA_LPC32XX
  47 #endif
  48
  49 /*
  50  * I2C
  51  */
  52 #define CONFIG_SYS_I2C
  53 #define CONFIG_SYS_I2C_LPC32XX
  54 #define CONFIG_SYS_I2C_SPEED            100000
  55
  56 /*
  57  * GPIO
  58  */
  59 #define CONFIG_LPC32XX_GPIO
  60
  61 /*
  62  * SSP/SPI
  63  */
  64 #define CONFIG_LPC32XX_SSP_TIMEOUT      100000
  65
  66 /*
  67  * Ethernet
  68  */
  69 #define CONFIG_RMII
  70 #define CONFIG_PHY_SMSC
  71 #define CONFIG_LPC32XX_ETH
  72 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  73
  74 /*
  75  * NOR Flash
  76  */
  77 #define CONFIG_SYS_MAX_FLASH_BANKS      1
  78 #define CONFIG_SYS_MAX_FLASH_SECT       71
  79 #define CONFIG_SYS_FLASH_BASE           EMC_CS0_BASE
  80 #define CONFIG_SYS_FLASH_SIZE           SZ_4M
  81
  82 /*
  83  * NAND controller
  84  */
  85 #define CONFIG_SYS_NAND_BASE            SLC_NAND_BASE
  86 #define CONFIG_SYS_MAX_NAND_DEVICE      1
  87 #define CONFIG_SYS_NAND_BASE_LIST       { CONFIG_SYS_NAND_BASE }
  88
  89 /*
  90  * NAND chip timings
  91  */
  92 #define CONFIG_LPC32XX_NAND_SLC_WDR_CLKS        14
  93 #define CONFIG_LPC32XX_NAND_SLC_WWIDTH          66666666
  94 #define CONFIG_LPC32XX_NAND_SLC_WHOLD           200000000
  95 #define CONFIG_LPC32XX_NAND_SLC_WSETUP          50000000
  96 #define CONFIG_LPC32XX_NAND_SLC_RDR_CLKS        14
  97 #define CONFIG_LPC32XX_NAND_SLC_RWIDTH          66666666
  98 #define CONFIG_LPC32XX_NAND_SLC_RHOLD           200000000
  99 #define CONFIG_LPC32XX_NAND_SLC_RSETUP          50000000
 100
 101 #define CONFIG_SYS_NAND_BLOCK_SIZE              0x20000
 102 #define CONFIG_SYS_NAND_PAGE_SIZE               NAND_LARGE_BLOCK_PAGE_SIZE
 103 #define CONFIG_SYS_NAND_USE_FLASH_BBT
 104
 105 /*
 106  * USB
 107  */
 108 #define CONFIG_USB_OHCI_LPC32XX
 109 #define CONFIG_USB_ISP1301_I2C_ADDR             0x2d
 110
 111 /*
 112  * U-Boot General Configurations
 113  */
 114 #define CONFIG_SYS_CBSIZE               1024
 115 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 116
 117 /*
 118  * Pass open firmware flat tree
 119  */
 120
 121 /*
 122  * Environment
 123  */
 124 #define CONFIG_ENV_SIZE                 SZ_128K
 125 #define CONFIG_ENV_OFFSET               0x000A0000
 126
 127 #define CONFIG_BOOTCOMMAND                      \
 128         "dhcp; "                                \
 129         "tftp ${loadaddr} ${serverip}:${tftpdir}/${bootfile}; "         \
 130         "tftp ${dtbaddr} ${serverip}:${tftpdir}/devkit3250.dtb; "       \
 131         "setenv nfsargs ip=dhcp root=/dev/nfs nfsroot=${serverip}:${nfsroot},tcp; "     \
 132         "setenv bootargs ${bootargs} ${nfsargs} ${userargs}; "                  \
 133         "bootm ${loadaddr} - ${dtbaddr}"
 134
 135 #define CONFIG_EXTRA_ENV_SETTINGS               \
 136         "autoload=no\0"                         \
 137         "ethaddr=00:01:90:00:C0:81\0"           \
 138         "dtbaddr=0x81000000\0"                  \
 139         "nfsroot=/opt/projects/images/vladimir/oe/devkit3250/rootfs\0"  \
 140         "tftpdir=vladimir/oe/devkit3250\0"      \
 141         "userargs=oops=panic\0"
 142
 143 /*
 144  * U-Boot Commands
 145  */
 146
 147 /*
 148  * Boot Linux
 149  */
 150 #define CONFIG_CMDLINE_TAG
 151 #define CONFIG_SETUP_MEMORY_TAGS
 152
 153 #define CONFIG_BOOTFILE                 "uImage"
 154 #define CONFIG_LOADADDR                 0x80008000
 155
 156 /*
 157  * SPL specific defines
 158  */
 159 /* SPL will be executed at offset 0 */
 160
 161 /* SPL will use SRAM as stack */
 162 #define CONFIG_SPL_STACK                0x0000FFF8
 163
 164 /* Use the framework and generic lib */
 165
 166 /* SPL will use serial */
 167
 168 /* SPL loads an image from NAND */
 169 #define CONFIG_SPL_NAND_RAW_ONLY
 170 #define CONFIG_SPL_NAND_DRIVERS
 171
 172 #define CONFIG_SPL_NAND_ECC
 173 #define CONFIG_SPL_NAND_SOFTECC
 174
 175 #define CONFIG_SPL_MAX_SIZE             0x20000
 176 #define CONFIG_SPL_PAD_TO               CONFIG_SPL_MAX_SIZE
 177
 178 /* U-Boot will be 0x60000 bytes, loaded and run at CONFIG_SYS_TEXT_BASE */
 179 #define CONFIG_SYS_NAND_U_BOOT_OFFS     0x40000
 180 #define CONFIG_SYS_NAND_U_BOOT_SIZE     0x60000
 181
 182 #define CONFIG_SYS_NAND_U_BOOT_START    CONFIG_SYS_TEXT_BASE
 183 #define CONFIG_SYS_NAND_U_BOOT_DST      CONFIG_SYS_TEXT_BASE
 184
 185 /* See common/spl/spl.c  spl_set_header_raw_uboot() */
 186 #define CONFIG_SYS_MONITOR_LEN          CONFIG_SYS_NAND_U_BOOT_SIZE
 187
 188 /*
 189  * Include SoC specific configuration
 190  */
 191 #include <asm/arch/config.h>
 192
 193 #endif  /* __CONFIG_DEVKIT3250_H__*/