2 tristate "ImgTec IR Decoder"
4 select IR_IMG_HW if !IR_IMG_RAW
6 Say Y or M here if you want to use the ImgTec infrared decoder
7 functionality found in SoCs such as TZ1090.
13 Say Y here to enable the raw mode driver which passes raw IR signal
14 changes to the IR raw decoders for software decoding. This is much
15 less reliable (due to lack of timestamps) and consumes more
16 processing power than using hardware decode, but can be useful for
17 testing, debug, and to make more protocols available.
20 bool "Hardware decoder"
23 Say Y here to enable the hardware decode driver which decodes the IR
24 signals in hardware. This is more reliable, consumes less processing
25 power since only a single interrupt is received for each scancode,
26 and allows an IR scancode to be used as a wake event.
29 bool "NEC protocol support"
32 Say Y here to enable support for the NEC, extended NEC, and 32-bit
33 NEC protocols in the ImgTec infrared decoder block.
36 bool "JVC protocol support"
39 Say Y here to enable support for the JVC protocol in the ImgTec
40 infrared decoder block.
43 bool "Sony protocol support"
46 Say Y here to enable support for the Sony protocol in the ImgTec
47 infrared decoder block.
50 bool "Sharp protocol support"
53 Say Y here to enable support for the Sharp protocol in the ImgTec
54 infrared decoder block.
57 bool "Sanyo protocol support"
60 Say Y here to enable support for the Sanyo protocol (used by Sanyo,
61 Aiwa, Chinon remotes) in the ImgTec infrared decoder block.