sun50i: h5: Add initial NanoPi NEO2 support

[oweals/u-boot.git] / include / configs / o2dnt-common.h

diff --git a/include/configs/o2dnt-common.h b/include/configs/o2dnt-common.h
index 1470c513a38459126129d7738ccac93efea3b0c6..1b4200bcbffc8fcd881454442aee18fee4b7e1f0 100644 (file)
--- a/include/configs/o2dnt-common.h
+++ b/include/configs/o2dnt-common.h
@@ -68,13 +68,9 @@
 /*
  * Supported commands
  */
-#define CONFIG_CMD_EEPROM
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
 #endif
-#ifdef CONFIG_POST
-#define CONFIG_CMD_DIAG
-#endif
 
 #if (CONFIG_SYS_TEXT_BASE == 0xFC000000) || (CONFIG_SYS_TEXT_BASE == 0xFF000000)
 /* Boot low with 16 or 32 MB Flash */
@@ -175,27 +171,6 @@
 #define CONFIG_SYS_PCICLK_EQUALS_IPBCLK_DIV2   /* define for 66MHz speed */
 #endif
 
-/*
- * I2C configuration
- */
-#define CONFIG_HARD_I2C                        1       /* I2C with hardware support */
-#define CONFIG_SYS_I2C_MODULE          1       /* Select I2C module #1 or #2 */
-#define CONFIG_SYS_I2C_SPEED           100000  /* 100 kHz */
-#define CONFIG_SYS_I2C_SLAVE           0x7F
-
-/*
- * EEPROM configuration:
- *
- * O2DNT board is equiped with Ramtron FRAM device FM24CL16
- * 16 Kib Ferroelectric Nonvolatile serial RAM memory
- * organized as 2048 x 8 bits and addressable as eight I2C devices
- * 0x50 ... 0x57 each 256 bytes in size
- *
- */
-#define CONFIG_SYS_I2C_FRAM
-#define CONFIG_SYS_I2C_EEPROM_ADDR             0x50    /* 1010000x */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN         1
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS      3
 /*
  * There is no write delay with FRAM, write operations are performed at bus
  * speed. Thus, no status polling or write delay is needed.