colibri_imx6: fix video stdout in default environment

[oweals/u-boot.git] / doc / README.omap3

diff --git a/doc/README.omap3 b/doc/README.omap3
index 0a37de0c7670f7b85c13e91092049226600ad5e9..8c3667b10cd18439cbfbc4dcd69f2b5e1da4c2e8 100644 (file)
--- a/doc/README.omap3
+++ b/doc/README.omap3
@@ -23,13 +23,6 @@ Currently the following boards are supported:
 
 * CompuLab Ltd. CM-T35 [8]
 
-Toolchain
-=========
-
-While ARM Cortex-A8 support ARM v7 instruction set (-march=armv7a) we compile
-with -march=armv5 to allow more compilers to work. For U-Boot code this has
-no performance impact.
-
 Build
 =====
 
@@ -48,11 +41,6 @@ make
 make omap3_evm_config
 make
 
-* Pandora:
-
-make omap3_pandora_config
-make
-
 * Zoom MDK:
 
 make omap3_zoom1_config
@@ -68,10 +56,6 @@ make
 make cm_t35_config
 make
 
-* BlueLYNX-X:
-
-make omap3_mvblx_config
-make
 
 Custom commands
 ===============
@@ -145,6 +129,33 @@ int omap3_dma_wait_for_transfer(uint32_t chan)
 int omap3_dma_get_revision(uint32_t *minor, uint32_t *major)
        Read silicon Revision of the DMA module
 
+NAND
+====
+
+There are some OMAP3 devices out there with NAND attached. Due to the fact that
+OMAP3 ROM code can only handle 1-bit hamming ECC for accessing first page
+(place where SPL lives) we require this setup for u-boot at least when reading
+the second progam within SPL.  A lot of newer NAND chips however require more
+than 1-bit ECC for the pages, some can live with 1-bit for the first page. To
+handle this we can switch to another ECC algorithm after reading the payload
+within SPL.
+
+BCH8
+----
+
+To enable hardware assisted BCH8 (8-bit BCH [Bose, Chaudhuri, Hocquenghem]) on
+OMAP3 devices we can use the BCH library in lib/bch.c. To do so add CONFIG_BCH
+and set CONFIG_NAND_OMAP_ECCSCHEME=5 (refer README.nand) for selecting BCH8_SW.
+The NAND OOB layout is the same as in linux kernel, if the linux kernel BCH8
+implementation for OMAP3 works for you so the u-boot version should also.
+When you require the SPL to read with BCH8 there are two more configs to
+change:
+
+ * CONFIG_SYS_NAND_ECCPOS (must be the same as .eccpos in
+   GPMC_NAND_HW_BCH8_ECC_LAYOUT defined in
+   arch/arm/include/asm/arch-omap3/omap_gpmc.h)
+ * CONFIG_SYS_NAND_ECCSIZE must be 512
+ * CONFIG_SYS_NAND_ECCBYTES must be 13 for this BCH8 setup
 
 Acknowledgements
 ================