x86: apl: Use devicetree for FSP-M configuration

[oweals/u-boot.git] / doc / README.nand

diff --git a/doc/README.nand b/doc/README.nand
index 2295bb2d962a18e6c57ef415058cfb331ba1db59..ec461b2dc933b315a971607ee24a14e03a35e024 100644 (file)
--- a/doc/README.nand
+++ b/doc/README.nand
@@ -1,3 +1,4 @@
+# SPDX-License-Identifier: GPL-2.0+
 NAND FLASH commands and notes
 
 See NOTE below!!!
@@ -5,7 +6,6 @@ See NOTE below!!!
 # (C) Copyright 2003
 # Dave Ellis, SIXNET, dge@sixnetio.com
 #
-# SPDX-License-Identifier:     GPL-2.0+
 
 Commands:
 
@@ -116,7 +116,7 @@ Configuration Options:
       The maximum number of NAND chips per device to be supported.
 
    CONFIG_SYS_NAND_SELF_INIT
-      Traditionally, glue code in drivers/mtd/nand/nand.c has driven
+      Traditionally, glue code in drivers/mtd/nand/raw/nand.c has driven
       the initialization process -- it provides the mtd and nand
       structs, calls a board init function for a specific device,
       calls nand_scan(), and registers with mtd.
@@ -125,7 +125,7 @@ Configuration Options:
       run code between nand_scan_ident() and nand_scan_tail(), or other
       deviations from the "normal" flow.
 
-      If a board defines CONFIG_SYS_NAND_SELF_INIT, drivers/mtd/nand/nand.c
+      If a board defines CONFIG_SYS_NAND_SELF_INIT, drivers/mtd/nand/raw/nand.c
       will make one call to board_nand_init(), with no arguments.  That
       function is responsible for calling a driver init function for
       each NAND device on the board, that performs all initialization
@@ -180,12 +180,6 @@ Configuration Options:
        And fetching device parameters flashed on device, by parsing
        ONFI parameter page.
 
-   CONFIG_BCH
-       Enables software based BCH ECC algorithm present in lib/bch.c
-       This is used by SoC platforms which do not have built-in ELM
-       hardware engine required for BCH ECC correction.
-
-
 Platform specific options
 =========================
    CONFIG_NAND_OMAP_GPMC
@@ -286,7 +280,7 @@ NOTE:
 =====
 
 The Disk On Chip driver is currently broken and has been for some time.
-There is a driver in drivers/mtd/nand, taken from Linux, that works with
+There is a driver in drivers/mtd/nand/raw, taken from Linux, that works with
 the current NAND system but has not yet been adapted to the u-boot
 environment.