default 32
config SYS_TEXT_BASE
+ default 0x9c000000 if !SPL
+ default 0x80200000 if SPL
+
+config SPL_TEXT_BASE
default 0x9c000000
+config SPL_PAYLOAD
+ default "u-boot-lzma.img" if SPL_LZMA
+
+config BUILD_TARGET
+ default "u-boot-with-spl.bin" if SPL
+
choice
prompt "MediaTek MIPS SoC select"
select PINCTRL_MT7628
select MTK_SERIAL
select SYSRESET_RESETCTL
+ select SPL_SEPARATE_BSS if SPL
+ select SPL_INIT_STACK_WITHOUT_MALLOC_F if SPL
+ select SPL_LOADER_SUPPORT if SPL
+ select SPL_OF_CONTROL if SPL_DM
+ select SPL_SIMPLE_BUS if SPL_DM
+ select SPL_DM_SERIAL if SPL_DM
+ select SPL_CLK if SPL_DM && SPL_SERIAL_SUPPORT
+ select SPL_SYSRESET if SPL_DM
+ select SPL_OF_LIBFDT if SPL_OF_CONTROL
help
This supports MediaTek MT7628/MT7688.
config SUPPORTS_BOOT_RAM
bool
+config SPL_UART2_SPIS_PINMUX
+ bool "Use alternative pinmux for UART2 in SPL stage"
+ depends on SPL_SERIAL_SUPPORT
+ default n
+ help
+ Select this if the UART2 of your board is connected to GPIO 16/17
+ (shared with SPIS) rather than the usual GPIO 20/21.
+
source "board/gardena/smart-gateway-mt7688/Kconfig"
source "board/seeed/linkit-smart-7688/Kconfig"