clk: rk3399: Enable/Disable the PCIEPHY clk

[oweals/u-boot.git] / README

diff --git a/README b/README
index 841412bacc676e82ee42185f47568f2330ff2f83..be9e6391d6b8f90e1151abb5883f4b0a67d56753 100644 (file)
--- a/README
+++ b/README
@@ -896,8 +896,6 @@ The following options need to be configured:
 
                CONFIG_TULIP
                Support for Digital 2114x chips.
-               Optional CONFIG_TULIP_SELECT_MEDIA for board specific
-               modem chip initialisation (KS8761/QS6611).
 
                CONFIG_NATSEMI
                Support for National dp83815 chips.
@@ -1632,16 +1630,6 @@ The following options need to be configured:
                  - activate this driver with CONFIG_SYS_I2C_RCAR
                  - This driver adds 4 i2c buses
 
-                 - CONFIG_SYS_RCAR_I2C0_BASE for setting the register channel 0
-                 - CONFIG_SYS_RCAR_I2C0_SPEED for for the speed channel 0
-                 - CONFIG_SYS_RCAR_I2C1_BASE for setting the register channel 1
-                 - CONFIG_SYS_RCAR_I2C1_SPEED for for the speed channel 1
-                 - CONFIG_SYS_RCAR_I2C2_BASE for setting the register channel 2
-                 - CONFIG_SYS_RCAR_I2C2_SPEED for for the speed channel 2
-                 - CONFIG_SYS_RCAR_I2C3_BASE for setting the register channel 3
-                 - CONFIG_SYS_RCAR_I2C3_SPEED for for the speed channel 3
-                 - CONFIF_SYS_RCAR_I2C_NUM_CONTROLLERS for number of i2c buses
-
                - drivers/i2c/sh_i2c.c:
                  - activate this driver with CONFIG_SYS_I2C_SH
                  - This driver adds from 2 to 5 i2c buses
@@ -2485,14 +2473,6 @@ Configuration Settings:
 - CONFIG_SYS_BAUDRATE_TABLE:
                List of legal baudrate settings for this board.
 
-- CONFIG_SYS_MEMTEST_START, CONFIG_SYS_MEMTEST_END:
-               Begin and End addresses of the area used by the
-               simple memory test.
-
-- CONFIG_SYS_MEMTEST_SCRATCH:
-               Scratch address used by the alternate memory test
-               You only need to set this if address zero isn't writeable
-
 - CONFIG_SYS_MEM_RESERVE_SECURE
                Only implemented for ARMv8 for now.
                If defined, the size of CONFIG_SYS_MEM_RESERVE_SECURE memory