Summary ======= Note: this document used to be about the entire family of DaVinci SOCs but the support for the DM* family and DA830 has since been dropped. This README is about U-Boot support for TI's DA850 SoC. This SOC has an OMAP part number but is very similar to the DaVinci series. Currently the following boards are supported: * TI DA850 EVM * TI OMAP-L138 LCDK * Lego EV3 Build ===== * TI DA850 EVM: make da850evm_config make * TI OMAP-L138 LCDK make omapl138_lcdk_defconfig make * Lego EV3 make legoev3_defconfig make Bootloaders =============== For DA850 an SPL (secondary program loader, see doc/README.SPL) is provided to load U-Boot directly from SPI flash. The SPL takes care of the low level initialization. The SPL is built as u-boot.ais for all DA850 defconfigs. The resulting image file can be programmed to the SPI flash of the DA850 EVM/LCDK. Environment Variables ===================== The DA850 EVM allows the user to specify the maximum cpu clock allowed by the silicon, in Hz, via an environment variable "maxcpuclk". The maximum clock rate allowed depends on the silicon populated on the EVM. Please make sure you understand the restrictions placed on this clock in the device specific datasheet before setting up this variable. This information is passed to the Linux kernel using the ATAG_REVISION atag. If "maxcpuclk" is not defined, the configuration CONFIG_DA850_EVM_MAX_CPU_CLK is used to obtain this information. Links ===== 1) TI DA850 EVM http://focus.ti.com/docs/prod/folders/print/omap-l138.html http://www.logicpd.com/products/development-kits/zoom-omap-l138-evm-development-kit 2) TI OMAP-L138 LCDK http://focus.ti.com/docs/prod/folders/print/omap-l138.html http://www.ti.com/tool/TMDXLCDK138 Davinci special defines ======================= CONFIG_SYS_DV_NOR_BOOT_CFG: AM18xx based boards, booting in NOR Boot mode need a "NOR Boot Configuration Word" stored in the NOR Flash. This define adds this. More Info about this, see: spraba5a.pdf chapter 3.1