X-Git-Url: https://git.librecmc.org/?p=oweals%2Ftinc.git;a=blobdiff_plain;f=README;h=9cc1042f08e40058523e5789130403e3d9f62cbd;hp=23b24581dd56073977b820192d66ee276617701e;hb=74653beb5bc510e60579058ee15c0f66350f5137;hpb=c81f90b91a054eeafcc3c8c45abc52045e4a8146 diff --git a/README b/README index 23b2458..9cc1042 100644 --- a/README +++ b/README @@ -1,7 +1,7 @@ -This is the README file for tinc version 1.0.9. Installation +This is the README file for tinc version 1.0.12. Installation instructions may be found in the INSTALL file. -tinc is Copyright (C) 1998-2008 by: +tinc is Copyright (C) 1998-2010 by: Ivo Timmermans, Guus Sliepen , @@ -55,7 +55,7 @@ should be changed into "Device", and "Device" should be changed into Compatibility ------------- -Version 1.0.9 is compatible with 1.0pre8, 1.0 and later, but not with older +Version 1.0.12 is compatible with 1.0pre8, 1.0 and later, but not with older versions of tinc. @@ -115,8 +115,7 @@ Support for routing IPv6 packets has been added. Just add Subnet lines with IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from the iproute package) to give the virtual network interface corresponding IPv6 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need -it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD, -Windows and possibly OpenBSD. +it use radvd or zebra. It is also possible to make tunnels to other tinc daemons over IPv6 networks, if the operating system supports IPv6. tinc will automatically use both IPv6