oweals/u-boot.git
2010-10-19 Andreas Bießmannat91rm9200ek: enbable USB support
2010-10-19 Andreas Bießmannat91rm9200: enable USB support
2010-10-19 Andreas Bießmannat91rm9200ek: convert to at91
2010-10-18 Joakim Tjernlunddlmalloc.c: Fix gcc alias warning
2010-10-18 Joakim Tjernlundpowerpc: do not fixup NULL ptrs
2010-10-18 Peter Tyserpowerpc: Cleanup BOOTFLAG_* references
2010-10-18 Damien DushaMPC5121: Add USB EHCI support
2010-10-18 Wolfgang DenkMerge branch 'master' of /home/wd/git/u-boot/master/
2010-10-18 Enric Balletbo... MAINTAINERS: Fix alphabetical order in ARM subsection
2010-10-18 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-nand...
2010-10-18 Wolfgang Denkconfig.mk cleanup: drop "-I$(TOPDIR)/board" entries
2010-10-18 Wolfgang DenkMAKEALL: allow additional board selections
2010-10-18 Wolfgang DenkMakefile: move all Power Architecture boards into board...
2010-10-18 Wolfgang Denkautoconfig.mk: avoid apostophes around hex values
2010-10-18 Wolfgang DenkRename TEXT_BASE into CONFIG_SYS_TEXT_BASE
2010-10-18 Wolfgang Denkmkconfig: change CONFIG_MK_ prefix into plain CONFIG_
2010-10-18 Marek VasutBuild: Add "board options" column to boards.cfg
2010-10-18 Wolfgang DenkMakefile: clean MatrixVision builds
2010-10-18 Scott WoodFix warning in nand unlock command
2010-10-18 Kim Phillipsmpc83xx: fix 837x MDS PCI HOST build
2010-10-18 Wolfgang DenkMPC832XEMDS: fix pci.c build warning
2010-10-18 Wolfgang Denklogodl: remove code for yet another corpse
2010-10-18 Wolfgang Denkschmoogie: fix build error due to removal of forceenv()
2010-10-18 Wolfgang DenkFPGA: fix support for non-Lattice devices
2010-10-17 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-arm
2010-10-17 Ben Gardinerda850evm: fix linux bootparam address
2010-10-17 Ben Gardinerda850evm: basic MII EMAC support
2010-10-17 Ben Gardinerda850evm: add mtdpart and ubi commands with NAND support
2010-10-17 Ben Gardinerda850evm: setup NAND support under CONFIG_USE_NAND
2010-10-17 Ben Gardinerda850evm: setup the NAND flash timings
2010-10-17 Ben Gardinerda850evm : enable NAND even when not in NAND boot mode
2010-10-17 Ben Gardinerdavinci_nand, trivial : use symbolic ECC start command
2010-10-17 Enric Balletbo... OMAP3: Add support for the OMAP3 IGEP module.
2010-10-17 Enric Balletbo... OMAP3: Add support for the IGEP v2 board.
2010-10-17 Enric Balletbo... OMAP3: SDRC: Introduce Numonyx DDR type
2010-10-17 Steve SakomanARMV7: OMAP4: Implement relocation for Panda and OMAP44...
2010-10-17 Steve SakomanARMV7: OMAP3: Fix bug in get_sdr_cs_offset()
2010-10-17 Steve SakomanARMV7: OMAP3: Enable cache support on Overo
2010-10-17 Steve SakomanARMV7: OMAP3: Implement relocation for Overo
2010-10-17 Sukumar GhoraiARMV7: OMAP4: Enable saveenv to eMMC for SDP4430
2010-10-17 Steve SakomanARMV7: OMAP4: Use generic mmc driver on Overo
2010-10-17 Steve SakomanARMV7: OMAP4: Use generic mmc driver on Beagle
2010-10-17 Sukumar GhoraiARMV7: OMAP4: Use generic mmc driver on SDP4430
2010-10-17 Sukumar GhoraiARMV7: OMAP4: Use generic mmc driver on Panda
2010-10-17 Sukumar GhoraiARMV7: OMAP: Add new mmc driver compatible with CONFIG_...
2010-10-17 Sukumar GhoraiMMC: Fix for capacity calculation on eMMC
2010-10-17 Steve SakomanARMV7: OMAP: Use default vendor/product ID for USB...
2010-10-17 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-imx
2010-10-15 Mike FrysingerBlackfin: workaround anomaly 05000440
2010-10-15 Mike FrysingerBlackfin: update anomaly lists to latest sheets
2010-10-14 Loic Miniermx51evk: add u-boot.imx to ALL target
2010-10-13 Lei Wenenv_mmc: fix cannot save env issue
2010-10-13 Stefan Roesens16550: Add WATCHDOG_RESET to putc for short watchdog...
2010-10-13 Steve Sakomanenv_mmc: Fix crashing bug encountered after enabling...
2010-10-13 Peter Tyserppc: Conditionally compile bat_rw.c
2010-10-13 mark.vels@team... Fix define for MPC5121 ADS board.
2010-10-13 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-arm
2010-10-13 Wolfgang DenkMerge branch 'sf' of git://git.denx.de/u-boot-blackfin
2010-10-13 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-usb
2010-10-13 Matthew McClintockcommon/fdt_support.c: fix compile error
2010-10-13 Stefano BabicMX31: Add USB Host support to the QONG board
2010-10-13 Stefano BabicMX31: Add support for MXC EHCI controller
2010-10-13 Stefano BabicMX31: add support for setting pin pads
2010-10-13 Stefano BabicMX31: Add support to update FPGA bitstream
2010-10-13 Stefano BabicMX31: Adding missing iomux pin to MX.31 registers
2010-10-13 Stefano BabicFPGA: add support for downloading Lattice bitstream
2010-10-13 Bryan Wuusb: musb: only write CLRDATATOG when appropriate
2010-10-13 Ludovic Courtèsusb: Add support for multiple-LUN mass storage devices
2010-10-13 Vitaly KuzmichevUSB-CDC: Prevent rx_req being enqueued twice
2010-10-13 Vitaly KuzmichevUSB-CDC: Fix tx/rx_req memory leaks
2010-10-13 Marek VasutUSB: Make non-bulk delay longer in OHCI
2010-10-13 Andreas Bießmannboard/armltd/integrator/split_by_variant.sh: fix 'echo -n'
2010-10-13 Matt WaddelARMV7: Fixed baudrate setting in pl01x driver
2010-10-13 Matt WaddelARMV7: Versatile Express Coretile CortexA9x4 support
2010-10-13 Andreas Bießmannarch/arm/include/asm/sizes.h: cleanups
2010-10-13 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-marvell
2010-10-13 Ben GardinerARM: relocation: don't undef CONFIG_SYS_ARM_WITHOUT_RELOC
2010-10-13 Heiko SchocherARM: relocation: fix typo in comment
2010-10-13 Prafulla WadaskarKirkwood: Changes specific to ARM relocation support
2010-10-13 Prafulla Wadaskarkirkwood: added common config file mv-common.h
2010-10-13 Prafulla WadaskarKirkwood: dram_init is moved to dram.c
2010-10-13 Albert Aribaudorion5x: optimize window size computation
2010-10-13 Prafulla WadaskarKirkwood: print_cpuinfo fixed for valid devid revid
2010-10-13 Albert Aribaudmvsata_ide: adjust port init sequence
2010-10-13 Reinhard Meyersf: turn probe switch into a lookup table
2010-10-12 Brent DarleyTSI148: Fix argument parsing
2010-10-12 Peter Tyserpowerpc: Remove warm reset entry point
2010-10-12 Peter Tyserppmc7xx: Use _start as reset entry point
2010-10-12 Peter Tyserpowerpc: Zero out board info struct on bootup
2010-10-12 Stefan Roesecp/cmp: Add WATCHDOG_RESET in copy and compare loop
2010-10-12 Peter Tyserexamples/standalone: Use gcc's -fno-toplevel-reorder
2010-10-12 Ilya Yanoka4m072: support for SHOW_BOOT_PROGRESS feature using...
2010-10-12 Ilya Yanoka4m072: led display support
2010-10-12 Ilya Yanokled_display: split led display support into generic...
2010-10-12 Sergei PoselenovA4M072: Added support for the board.
2010-10-12 Mikhail ZolotaryovVFAT: fix processing of scattered long file name entries
2010-10-12 Daniel Hobitools/imls: fix comment in Makefile
2010-10-12 Lei Wenenv: don't set to default env twice when use CONFIG_ENV...
2010-10-12 Stefan Roesezlib: Add further watchdog reset calls
2010-10-12 Stefan Roesezlib/gunzip: Use WATCHDOG_RESET macro
next