From fca94c3fd5deef33442813475a5af1650f2d2830 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Sat, 3 Mar 2012 21:21:13 +0100 Subject: [PATCH] integrator: remove fragile delay loop from PCI code MIME-Version: 1.0 Content-Type: text/plain; charset=utf8 Content-Transfer-Encoding: 8bit The reference implementation of the PCI initialization code almost everywhere contain this fragile loop of "a few usecs", and its use of volatile variables to delay a number of bus cycles is indeed uncertain. Reading the manual "Integrator/AP Users Guide", page 5-15 it is clearly stated: "Wait until 230ms after the end of the reset period before accessing V360EPC internal registers. The V360EPC supports the use of a serial configuration PROM and the software must wait for the device to detect the absence of this PROM before accessing any registers. The required delay is a function of the PCI Clock, but at the lower frequency (25MHz) is 230ms". So let's simply wait 230ms per the spec. This solves the compilation error that looked like this: pci.c: In function ‘pci_init_board’: pci.c:286:18: warning: variable ‘j’ set but not used Reported-by: Wolfgang Denk Signed-off-by: Linus Walleij --- board/armltd/integrator/pci.c | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-) diff --git a/board/armltd/integrator/pci.c b/board/armltd/integrator/pci.c index f040450417..8ff88fef0a 100644 --- a/board/armltd/integrator/pci.c +++ b/board/armltd/integrator/pci.c @@ -283,17 +283,14 @@ struct pci_controller integrator_hose = { void pci_init_board(void) { - volatile int i, j; struct pci_controller *hose = &integrator_hose; u16 val; /* setting this register will take the V3 out of reset */ __raw_writel(SC_PCI_PCIEN, SC_PCI); - /* wait a few usecs to settle the device and the PCI bus */ - - for (i = 0; i < 100; i++) - j = i + 1; + /* Wait for 230 ms (from spec) before accessing any V3 registers */ + mdelay(230); /* Now write the Base I/O Address Word to PHYS_PCI_V3_BASE + 0x6E */ v3_writew(V3_LB_IO_BASE, (PHYS_PCI_V3_BASE >> 16)); -- 2.25.1