From f2cca34245c119cc7fe3cf48646e31133a1bdffe Mon Sep 17 00:00:00 2001 From: Suriyan Ramasami Date: Thu, 20 Nov 2014 17:26:30 -0800 Subject: [PATCH] odroid: usbhost - Add missing gpio_request call The USB host code was missing gpio_request() calls before using the gpio functions, causing errors to be printed out. As a side note calls to max77686_set_buck_mode(OPMODE_OFF/OPMODE_ON) have been removed, as they did not have any effect. This is as per Przemyslaw: I looked into the documentation and there is a "ENB8" pin in PMIC package. This pin allows steering BUCK8 ON/OFF by the hardware. If ENB8 is set to low then you can do on/off. If high, then you cannot change its state by I2C write, which seems to be the case with the Odroids. Signed-off-by: Suriyan Ramasami Acked-by: Przemyslaw Marczak Signed-off-by: Minkyu Kang --- board/samsung/odroid/odroid.c | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/board/samsung/odroid/odroid.c b/board/samsung/odroid/odroid.c index f7396ab4c4..a2c008e76e 100644 --- a/board/samsung/odroid/odroid.c +++ b/board/samsung/odroid/odroid.c @@ -382,6 +382,17 @@ static void board_gpio_init(void) gpio_set_pull(EXYNOS4X12_GPIO_X31, S5P_GPIO_PULL_UP); gpio_set_drv(EXYNOS4X12_GPIO_X31, S5P_GPIO_DRV_4X); gpio_direction_input(EXYNOS4X12_GPIO_X31); + +#ifdef CONFIG_CMD_USB + /* USB3503A Reference frequency */ + gpio_request(EXYNOS4X12_GPIO_X30, "USB3503A RefFreq"); + + /* USB3503A Connect */ + gpio_request(EXYNOS4X12_GPIO_X34, "USB3503A Connect"); + + /* USB3503A Reset */ + gpio_request(EXYNOS4X12_GPIO_X35, "USB3503A Reset"); +#endif } static int pmic_init_max77686(void) @@ -489,10 +500,8 @@ int board_usb_init(int index, enum usb_init_type init) p_pmic = pmic_get("MAX77686_PMIC"); if (p_pmic && !pmic_probe(p_pmic)) { - max77686_set_buck_mode(p_pmic, 8, OPMODE_OFF); max77686_set_buck_voltage(p_pmic, 8, 750000); max77686_set_buck_voltage(p_pmic, 8, 3300000); - max77686_set_buck_mode(p_pmic, 8, OPMODE_ON); } #endif -- 2.25.1