From cf31914cf2cd681b3e3681523afbfffb8d8a119b Mon Sep 17 00:00:00 2001 From: Lukasz Majewski Date: Thu, 5 Sep 2019 09:55:00 +0200 Subject: [PATCH] mmc: Replace printf with debug call for timeouts in the i.MX28 mxs driver This change replaces printf() with debug() for the notification about commands timeouts. This is done on purpose (also other drivers use such approach - dw_mmc.c, mvebu_mmc.c), as the mmc core code (mmc.c) uses timeouts to assess if one is using sd card or eMMC device. In such situation timeout is a some kind of a "normal" behavior and there shall not be any output to the console. There is no impact on boot time for boards using this driver (even in SPL) when two extra timeouts are returned (no SD card present, only eMMC available). Boot time tested with grabserial: sudo grabserial -b 115200 -d /dev/ttyUSB1 -e 30 -t -m "^U-Boot SPL*" Signed-off-by: Lukasz Majewski --- drivers/mmc/mxsmmc.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/mxsmmc.c b/drivers/mmc/mxsmmc.c index 7ea47f9801..9414eff42b 100644 --- a/drivers/mmc/mxsmmc.c +++ b/drivers/mmc/mxsmmc.c @@ -432,8 +432,8 @@ mxsmmc_send_cmd(struct udevice *dev, struct mmc_cmd *cmd, struct mmc_data *data) /* Check command timeout */ if (reg & SSP_STATUS_RESP_TIMEOUT) { - printf("MMC%d: Command %d timeout (status 0x%08x)\n", - devnum, cmd->cmdidx, reg); + debug("MMC%d: Command %d timeout (status 0x%08x)\n", + devnum, cmd->cmdidx, reg); return -ETIMEDOUT; } -- 2.25.1