From b42711f90c66d683b808cd78d9748ab38407413f Mon Sep 17 00:00:00 2001 From: Bin Meng Date: Tue, 15 Aug 2017 22:38:30 -0700 Subject: [PATCH] x86: ich-spi: Move opcode registers configuration to another routine At present the ICH SPI opcode registers configuration is done in the ich_spi_remove() routine, a little bit weird but that's how current. Linux MTD driver works. This changes to move the opcode registers configuration to a separate routine ich_spi_config_opcode() which might be called by U-Boot itself as well. Signed-off-by: Bin Meng Reviewed-by: Stefan Roese --- drivers/spi/ich.c | 22 ++++++++++++++++------ 1 file changed, 16 insertions(+), 6 deletions(-) diff --git a/drivers/spi/ich.c b/drivers/spi/ich.c index d4888f5fa4..373bc2683b 100644 --- a/drivers/spi/ich.c +++ b/drivers/spi/ich.c @@ -338,6 +338,21 @@ static int ich_status_poll(struct ich_spi_priv *ctlr, u16 bitmask, return -ETIMEDOUT; } +void ich_spi_config_opcode(struct udevice *dev) +{ + struct ich_spi_priv *ctlr = dev_get_priv(dev); + + /* + * PREOP, OPTYPE, OPMENU1/OPMENU2 registers can be locked down + * to prevent accidental or intentional writes. Before they get + * locked down, these registers should be initialized properly. + */ + ich_writew(ctlr, SPI_OPPREFIX, ctlr->preop); + ich_writew(ctlr, SPI_OPTYPE, ctlr->optype); + ich_writel(ctlr, SPI_OPMENU_LOWER, ctlr->opmenu); + ich_writel(ctlr, SPI_OPMENU_UPPER, ctlr->opmenu + sizeof(u32)); +} + static int ich_spi_xfer(struct udevice *dev, unsigned int bitlen, const void *dout, void *din, unsigned long flags) { @@ -585,16 +600,11 @@ static int ich_spi_probe(struct udevice *dev) static int ich_spi_remove(struct udevice *bus) { - struct ich_spi_priv *ctlr = dev_get_priv(bus); - /* * Configure SPI controller so that the Linux MTD driver can fully * access the SPI NOR chip */ - ich_writew(ctlr, SPI_OPPREFIX, ctlr->preop); - ich_writew(ctlr, SPI_OPTYPE, ctlr->optype); - ich_writel(ctlr, SPI_OPMENU_LOWER, ctlr->opmenu); - ich_writel(ctlr, SPI_OPMENU_UPPER, ctlr->opmenu + sizeof(u32)); + ich_spi_config_opcode(bus); return 0; } -- 2.25.1