From 916ed9444d3ab7b5cd6312557005f2a764a8baf7 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Thu, 29 Oct 2009 18:37:45 +0100 Subject: [PATCH] ppc4xx: Canyonlands: Change EBC bus config to drive always (no high-z) This patch fixes a problem only seen very occasionally on Canyonlands. The NOR flash interface (CFI driver) doesn't work reliably in all cases. Erasing and/or programming sometimes doesn't work. Sometimes with an error message, like "flash not erased" when trying to program an area that should have just been erased. And sometimes without any error messages. As mentioned above, this problem was only seen rarely and with some PLL configuration (CPU speed, EBC speed). Now I spotted this problem a few times, when running my Canyonlands with the following setup (chip_config): 1000-nor - NOR CPU:1000 PLB: 200 OPB: 100 EBC: 100 Changing the EBC configuration to not release the bus into high impedance state inbetween the transfers (ATC, DTC and CTC bits set to 1 in EBC0_CFG) seems to fix this problem. I haven't seen any failure anymore with this patch applied. Signed-off-by: Stefan Roese Cc: David Mitchell Cc: Jeff Mann --- include/configs/canyonlands.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/include/configs/canyonlands.h b/include/configs/canyonlands.h index 3dddccfe7e..ac9b3c5053 100644 --- a/include/configs/canyonlands.h +++ b/include/configs/canyonlands.h @@ -593,7 +593,7 @@ #define CONFIG_SYS_EBC_PB1CR (CONFIG_SYS_FPGA_BASE | 0x3a000) /* BAS=FPGA,BS=2MB,BU=R/W,BW=16bit*/ #endif /* !defined(CONFIG_ARCHES) */ -#define CONFIG_SYS_EBC_CFG 0xB8400000 /* EBC0_CFG */ +#define CONFIG_SYS_EBC_CFG 0xbfc00000 /* * Arches doesn't use PerCS3 but GPIO43, so let's configure the GPIO -- 2.25.1