From 72739219a12bf02820d29a89cb2b7fdc4d0e840f Mon Sep 17 00:00:00 2001 From: Vikram Narayanan Date: Sat, 16 Jun 2012 07:16:17 +0000 Subject: [PATCH] tx25: Use generic gpio_* calls Instead of manipulating gpio registers directly, use the calls from the gpio library. Signed-off-by: Vikram Narayanan Acked-by: Stefano Babic Cc: John Rigby Cc: Fabio Estevam Acked-by: Fabio Estevam Acked-by: Stefano Babic --- board/karo/tx25/tx25.c | 25 +++++++++---------------- 1 file changed, 9 insertions(+), 16 deletions(-) diff --git a/board/karo/tx25/tx25.c b/board/karo/tx25/tx25.c index 2a29943733..07fd98d604 100644 --- a/board/karo/tx25/tx25.c +++ b/board/karo/tx25/tx25.c @@ -34,14 +34,13 @@ DECLARE_GLOBAL_DATA_PTR; #ifdef CONFIG_FEC_MXC +#define GPIO_FEC_RESET_B MXC_GPIO_PORT_TO_NUM(4, 7) +#define GPIO_FEC_ENABLE_B MXC_GPIO_PORT_TO_NUM(4, 9) void tx25_fec_init(void) { struct iomuxc_mux_ctl *muxctl; struct iomuxc_pad_ctl *padctl; - u32 val; u32 gpio_mux_mode = MX25_PIN_MUX_MODE(5); - struct gpio_regs *gpio4 = (struct gpio_regs *)IMX_GPIO4_BASE; - struct gpio_regs *gpio3 = (struct gpio_regs *)IMX_GPIO3_BASE; u32 saved_rdata0_mode, saved_rdata1_mode, saved_rx_dv_mode; debug("tx25_fec_init\n"); @@ -66,18 +65,15 @@ void tx25_fec_init(void) writel(0x0, &padctl->pad_d11); /* drop PHY power and assert reset (low) */ - val = readl(&gpio4->gpio_dr) & ~((1 << 7) | (1 << 9)); - writel(val, &gpio4->gpio_dr); - val = readl(&gpio4->gpio_dir) | (1 << 7) | (1 << 9); - writel(val, &gpio4->gpio_dir); + gpio_direction_output(GPIO_FEC_RESET_B, 0); + gpio_direction_output(GPIO_FEC_ENABLE_B, 0); mdelay(5); debug("resetting phy\n"); /* turn on PHY power leaving reset asserted */ - val = readl(&gpio4->gpio_dr) | 1 << 9; - writel(val, &gpio4->gpio_dr); + gpio_set_value(GPIO_FEC_ENABLE_B, 1); mdelay(10); @@ -107,19 +103,16 @@ void tx25_fec_init(void) /* * set each to 1 and make each an output */ - val = readl(&gpio3->gpio_dr) | (1 << 10) | (1 << 11) | (1 << 12); - writel(val, &gpio3->gpio_dr); - val = readl(&gpio3->gpio_dir) | (1 << 10) | (1 << 11) | (1 << 12); - writel(val, &gpio3->gpio_dir); + gpio_direction_output(MXC_GPIO_PORT_TO_NUM(3, 10), 1); + gpio_direction_output(MXC_GPIO_PORT_TO_NUM(3, 11), 1); + gpio_direction_output(MXC_GPIO_PORT_TO_NUM(3, 12), 1); mdelay(22); /* this value came from RedBoot */ /* * deassert PHY reset */ - val = readl(&gpio4->gpio_dr) | 1 << 7; - writel(val, &gpio4->gpio_dr); - writel(val, &gpio4->gpio_dr); + gpio_set_value(GPIO_FEC_RESET_B, 1); mdelay(5); -- 2.25.1