From 685dc83af4c8d007c63e0a4a1a3cb9549ce7039a Mon Sep 17 00:00:00 2001 From: Stephen Warren Date: Fri, 5 Feb 2016 22:45:46 -0700 Subject: [PATCH] ARM: rpi: update memory layout env. var. documentation Update rpi-common.h's documentation that describes the rationale for choosing various addresses for standardized variables used by boot scripts. This comment was correct when written, but not updated when some of the values were changed. Fixes: 14006a567105 ("rpi: set fdt_addr_r to 0x00000100 to match default ...device_tree_address") Cc: Jonathan Liu Cc: Daniel Stone Signed-off-by: Stephen Warren --- include/configs/rpi-common.h | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) diff --git a/include/configs/rpi-common.h b/include/configs/rpi-common.h index 927bae78eb..29510f5c9c 100644 --- a/include/configs/rpi-common.h +++ b/include/configs/rpi-common.h @@ -144,8 +144,14 @@ /* * Memory layout for where various images get loaded by boot scripts: * - * scriptaddr can be pretty much anywhere that doesn't conflict with something - * else. Put it low in memory to avoid conflicts. + * I suspect address 0 is used as the SMP pen on the RPi2, so avoid this. + * + * fdt_addr_r simply shouldn't overlap anything else. However, the RPi's + * binary firmware loads a DT to address 0x100, so we choose this address to + * match it. This allows custom boot scripts to pass this DT on to Linux + * simply by not over-writing the data at this address. When using U-Boot, + * U-Boot (and scripts it executes) typicaly ignore the DT loaded by the FW + * and loads its own DT from disk (triggered by boot.scr or extlinux.conf). * * pxefile_addr_r can be pretty much anywhere that doesn't conflict with * something else. Put it low in memory to avoid conflicts. @@ -159,11 +165,11 @@ * this up to 16M allows for a sizable kernel to be decompressed below the * compressed load address. * - * fdt_addr_r simply shouldn't overlap anything else. Choosing 32M allows for - * the compressed kernel to be up to 16M too. + * scriptaddr can be pretty much anywhere that doesn't conflict with something + * else. Choosing 32M allows for the compressed kernel to be up to 16M. * * ramdisk_addr_r simply shouldn't overlap anything else. Choosing 33M allows - * for the FDT/DTB to be up to 1M, which is hopefully plenty. + * for any boot script to be up to 1M, which is hopefully plenty. */ #define ENV_MEM_LAYOUT_SETTINGS \ "fdt_addr_r=0x00000100\0" \ -- 2.25.1