From 62d6bac66038163641d6ba43ac47347447fedb82 Mon Sep 17 00:00:00 2001 From: Christopher Spinrath Date: Tue, 12 Jul 2016 23:37:36 +0200 Subject: [PATCH] ARM: board: cm_fx6: fixup mtd partitions in the fdt The cm-fx6 module has an on-board st,m25p compatible spi flash chip used for U-Boot (binary & environment). Overwrite the partitions in the device tree by the partition table provided in the mtdparts environment variable, if it is set. This allows to specify a kernel independent partitioning in the environment and provides a convient way for the user to adapt the partition table. Signed-off-by: Christopher Spinrath Acked-by: Igor Grinberg --- board/compulab/cm_fx6/cm_fx6.c | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-) diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c index 712057a6c5..566c19b4c9 100644 --- a/board/compulab/cm_fx6/cm_fx6.c +++ b/board/compulab/cm_fx6/cm_fx6.c @@ -12,6 +12,7 @@ #include #include #include +#include #include #include #include @@ -28,6 +29,7 @@ #include #include #include +#include #include "common.h" #include "../common/eeprom.h" #include "../common/common.h" @@ -581,6 +583,17 @@ int cm_fx6_setup_ecspi(void) { return 0; } #ifdef CONFIG_OF_BOARD_SETUP #define USDHC3_PATH "/soc/aips-bus@02100000/usdhc@02198000/" + +struct node_info nodes[] = { + /* + * Both entries target the same flash chip. The st,m25p compatible + * is used in the vendor device trees, while upstream uses (the + * documented) jedec,spi-nor comptatible. + */ + { "st,m25p", MTD_DEV_TYPE_NOR, }, + { "jedec,spi-nor", MTD_DEV_TYPE_NOR, }, +}; + int ft_board_setup(void *blob, bd_t *bd) { u32 baseboard_rev; @@ -589,6 +602,8 @@ int ft_board_setup(void *blob, bd_t *bd) char baseboard_name[16]; int err; + fdt_shrink_to_minimum(blob); /* Make room for new properties */ + /* MAC addr */ if (eth_getenv_enetaddr("ethaddr", enetaddr)) { fdt_find_and_setprop(blob, @@ -607,7 +622,6 @@ int ft_board_setup(void *blob, bd_t *bd) return 0; /* Assume not an early revision SB-FX6m baseboard */ if (!strncmp("SB-FX6m", baseboard_name, 7) && baseboard_rev <= 120) { - fdt_shrink_to_minimum(blob); /* Make room for new properties */ nodeoffset = fdt_path_offset(blob, USDHC3_PATH); fdt_delprop(blob, nodeoffset, "cd-gpios"); fdt_find_and_setprop(blob, USDHC3_PATH, "broken-cd", @@ -616,6 +630,8 @@ int ft_board_setup(void *blob, bd_t *bd) NULL, 0, 1); } + fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes)); + return 0; } #endif -- 2.25.1