From 46e91674fb4b6d06c6a4984c0b5ac7d9a16923f4 Mon Sep 17 00:00:00 2001 From: Peter Tyser Date: Tue, 3 Nov 2009 17:52:07 -0600 Subject: [PATCH] tsec: Force TBI PHY to 1000Mbps full duplex in SGMII mode In SGMII mode the link between a processor's internal TBI PHY and an external PHY should always be 1000Mbps, full duplex. Also, the SGMII interface between an internal TBI PHY and external PHY does not support in-band auto-negotation. Previously, when configured for SGMII mode a TBI PHY would attempt to restart auto-negotation during initializtion. This auto-negotation between a TBI PHY and external PHY would fail and result in unusable ethernet operation. Forcing the TBI PHY and and external PHY to link at 1000Mbps full duplex in SGMII mode resolves this issue of auto-negotation failing. Note that 10Mbps and 100Mbps operation is still possible on the external side of the external PHY even when SGMII is operating at 1000Mbps. The SGMII interface still operates at 1000Mbps, but each byte of data is repeated 100 or 10 times for 10/100Mbps and the external PHY handles converting this data stream into proper 10/100Mbps signalling. Signed-off-by: Peter Tyser Signed-off-by: Ben Warren --- drivers/net/tsec.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/tsec.c b/drivers/net/tsec.c index d8b6619ae0..67441d4ea7 100644 --- a/drivers/net/tsec.c +++ b/drivers/net/tsec.c @@ -277,12 +277,13 @@ uint tsec_local_mdio_read(volatile tsec_mdio_t *phyregs, uint phyid, uint regnum | TBIANA_FULL_DUPLEX \ ) +/* Force the TBI PHY into 1000Mbps full duplex when in SGMII mode */ #define TBICR_SETTINGS ( \ TBICR_PHY_RESET \ - | TBICR_ANEG_ENABLE \ | TBICR_FULL_DUPLEX \ | TBICR_SPEED1_SET \ ) + /* Configure the TBI for SGMII operation */ static void tsec_configure_serdes(struct tsec_private *priv) { -- 2.25.1