From 21f4cbb77299788e2b06c9b0f48cf20a5ab00d4a Mon Sep 17 00:00:00 2001 From: Joakim Tjernlund Date: Thu, 17 Sep 2009 11:07:15 +0200 Subject: [PATCH] fsl_i2c: Wait for STOP condition to propagate After issuing a STOP one must wait until the STOP has completed on the bus before doing something new to the controller. Also add an extra read of SR as the manual mentions doing that is a good idea. Remove surplus write of CR just before a write, isn't required and could potentially disturb the I2C bus. Signed-off-by: Joakim Tjernlund --- drivers/i2c/fsl_i2c.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/i2c/fsl_i2c.c b/drivers/i2c/fsl_i2c.c index 47bbf792c4..56f9680063 100644 --- a/drivers/i2c/fsl_i2c.c +++ b/drivers/i2c/fsl_i2c.c @@ -223,7 +223,7 @@ i2c_init(int speed, int slaveadd) #endif } -static __inline__ int +static int i2c_wait4bus(void) { unsigned long long timeval = get_ticks(); @@ -248,6 +248,8 @@ i2c_wait(int write) csr = readb(&i2c_dev[i2c_bus_num]->sr); if (!(csr & I2C_SR_MIF)) continue; + /* Read again to allow register to stabilise */ + csr = readb(&i2c_dev[i2c_bus_num]->sr); writeb(0x0, &i2c_dev[i2c_bus_num]->sr); @@ -293,9 +295,6 @@ __i2c_write(u8 *data, int length) { int i; - writeb(I2C_CR_MEN | I2C_CR_MSTA | I2C_CR_MTX, - &i2c_dev[i2c_bus_num]->cr); - for (i = 0; i < length; i++) { writeb(data[i], &i2c_dev[i2c_bus_num]->dr); @@ -351,6 +350,9 @@ i2c_read(u8 dev, uint addr, int alen, u8 *data, int length) && i2c_write_addr(dev, I2C_READ_BIT, 1) != 0) i = __i2c_read(data, length); + if (length && i2c_wait4bus()) /* Wait until STOP */ + debug("i2c_read: wait4bus timed out\n"); + writeb(I2C_CR_MEN, &i2c_dev[i2c_bus_num]->cr); if (i == length) @@ -372,6 +374,8 @@ i2c_write(u8 dev, uint addr, int alen, u8 *data, int length) } writeb(I2C_CR_MEN, &i2c_dev[i2c_bus_num]->cr); + if (i2c_wait4bus()) /* Wait until STOP */ + debug("i2c_write: wait4bus timed out\n"); if (i == length) return 0; -- 2.25.1