From: INAGAKI Hiroshi Date: Tue, 8 Jan 2019 15:20:18 +0000 (+0900) Subject: ramips: add support for I-O DATA WN-AC1167GR X-Git-Tag: v19.07.0-rc1~1308 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=f305ce5c3577005aba5b870b373e65aaf9ede3ec;p=oweals%2Fopenwrt.git ramips: add support for I-O DATA WN-AC1167GR I-O DATA WN-AC1167GR is a 2.4/5 GHz band 11ac router, based on MediaTek MT7620A. Specification: - SoC : MediaTek MT7620A - RAM : DDR2 64 MB - Flash : SPI-NOR 8MB - WLAN : 2.4/5 GHz, 2T2R - 2.4 GHz: MT7620A (SoC) - 5 GHz : MT7612E - Ethernet: 10/100/1000 Mbps (ext. MT7530) - LED/key : 4x/3x (2x buttons, 1x slide-switch) - UART : through-hole on PCB - J2: TX, GND, RX, Vcc from SoC side - 115200n8 Flash instruction using factory image: 1. Boot WN-AC1167GR normaly 2. Access to "http://192.168.0.1/" and open firmware update page ("ファームウェア") 3. Select the OpenWrt factory image and click update ("更新") button to perform firmware update 4. Wait ~150 seconds to complete flashing Signed-off-by: INAGAKI Hiroshi --- diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index e36f125126..4e2d534c99 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -188,6 +188,10 @@ ht-tm02) ucidef_set_led_netdev "eth" "Ethernet" "$boardname:green:lan" "eth0" set_wifi_led "$boardname:blue:wlan" ;; +iodata,wn-ac1167gr) + ucidef_set_led_wlan "wlan5g" "WLAN5G" "$boardname:green:wlan5g" "phy0radio" + ucidef_set_led_wlan "wlan2g" "WLAN2G" "$boardname:green:wlan2g" "phy1radio" + ;; kimax,u35wf) set_wifi_led "$boardname:blue:wifi" ucidef_set_led_netdev "eth" "ETH" "$boardname:green:eth" "eth0" diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index 67f2b4998a..d84e738e89 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -319,6 +319,10 @@ ramips_setup_interfaces() ucidef_add_switch "switch0" \ "1:lan" "2:lan" "3:lan" "4:lan" "5:lan" "0:wan" "6@eth0" ;; + iodata,wn-ac1167gr) + ucidef_add_switch "switch1" \ + "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "0:wan" "6@eth0" + ;; kn_rf) ucidef_add_switch "switch0" \ "0:wan" "1:lan" "2:lan" "3:lan" "4:lan" "6@eth0" @@ -525,6 +529,9 @@ ramips_setup_macs() [ -n "$lan_mac" ] || lan_mac=$(cat /sys/class/net/eth0/address) wan_mac=$(macaddr_add "$lan_mac" 1) ;; + iodata,wn-ac1167gr) + wan_mac=$(macaddr_add "$(mtd_get_mac_binary Factory 4)" -1) + ;; iodata,wn-ax1167gr|\ iodata,wn-gx300gr) wan_mac=$(macaddr_add "$(mtd_get_mac_binary Factory 4)" 1) diff --git a/target/linux/ramips/dts/WN-AC1167GR.dts b/target/linux/ramips/dts/WN-AC1167GR.dts new file mode 100644 index 0000000000..14c851a3a8 --- /dev/null +++ b/target/linux/ramips/dts/WN-AC1167GR.dts @@ -0,0 +1,216 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "mt7620a.dtsi" + +#include +#include + +/ { + compatible = "iodata,wn-ac1167gr", "ralink,mt7620a-soc"; + model = "I-O DATA WN-AC1167GR"; + + aliases { + led-boot = &led_power; + led-failsafe = &led_power; + led-running = &led_power; + led-upgrade = &led_power; + }; + + memory@0 { + device_type = "memory"; + reg = <0x0 0x4000000>; + }; + + leds { + compatible = "gpio-leds"; + + led_power: power { + label = "wn-ac1167gr:green:power"; + gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + wlan2g { + label = "wn-ac1167gr:green:wlan2g"; + gpios = <&gpio0 10 GPIO_ACTIVE_LOW>; + }; + + notification { + label = "wn-ac1167gr:green:notification"; + gpios = <&gpio0 11 GPIO_ACTIVE_LOW>; + }; + + wlan5g { + label = "wn-ac1167gr:green:wlan5g"; + gpios = <&gpio0 14 GPIO_ACTIVE_LOW>; + }; + }; + + keys { + compatible = "gpio-keys-polled"; + poll-interval = <20>; + + wps { + label = "wps"; + gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + + reset { + label = "reset"; + gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + + auto { + label = "auto"; + gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; + linux,code = ; + linux,input-type = ; + }; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <10000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x30000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x30000 0x10000>; + read-only; + }; + + Factory: partition@40000 { + label = "Factory"; + reg = <0x40000 0x8000>; + read-only; + }; + + iNIC_rf: partition@48000 { + label = "iNIC_rf"; + reg = <0x48000 0x8000>; + read-only; + }; + + partition@50000 { + label = "NoUsed"; + reg = <0x50000 0x20000>; + read-only; + }; + + partition@70000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x70000 0x6b4000>; + }; + + partition@724000 { + label = "manufacture"; + reg = <0x724000 0x8c000>; + read-only; + }; + + partition@7b0000 { + label = "backup"; + reg = <0x7b0000 0x10000>; + read-only; + }; + + partition@7c0000 { + label = "storage"; + reg = <0x7c0000 0x40000>; + read-only; + }; + }; + }; +}; + +ðernet { + pinctrl-names = "default"; + pinctrl-0 = <&rgmii1_pins &mdio_pins>; + mtd-mac-address = <&Factory 0x4>; + + port@5 { + status = "okay"; + mediatek,fixed-link = <1000 1 1 1>; + phy-mode = "rgmii"; + }; + + mdio-bus { + #address-cells = <1>; + #size-cells = <0>; + status = "okay"; + + ethernet-phy@0 { + reg = <0>; + phy-mode = "rgmii"; + }; + + ethernet-phy@1 { + reg = <1>; + phy-mode = "rgmii"; + }; + + ethernet-phy@2 { + reg = <2>; + phy-mode = "rgmii"; + }; + + ethernet-phy@3 { + reg = <3>; + phy-mode = "rgmii"; + }; + + ethernet-phy@4 { + reg = <4>; + phy-mode = "rgmii"; + }; + + ethernet-phy@1f { + reg = <0x1f>; + phy-mode = "rgmii"; + }; + }; +}; + +&pinctrl { + state_default: pinctrl0 { + gpio { + ralink,group = "i2c", "uartf"; + ralink,function = "gpio"; + }; + }; +}; + +&pcie { + status = "okay"; +}; + +&pcie0 { + wifi@0,0 { + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&iNIC_rf 0x0>; + ieee80211-freq-limit = <5000000 6000000>; + }; +}; + +&wmac { + ralink,mtd-eeprom = <&Factory 0x0>; +}; diff --git a/target/linux/ramips/image/mt7620.mk b/target/linux/ramips/image/mt7620.mk index 57903232ed..7ac228db16 100644 --- a/target/linux/ramips/image/mt7620.mk +++ b/target/linux/ramips/image/mt7620.mk @@ -16,6 +16,25 @@ define Build/elecom-header -f $@ -C $(KDIR) v_0.0.0.bin v_0.0.0.md5 endef +define Build/elx-header + $(eval hw_id=$(word 1,$(1))) + $(eval xor_pattern=$(word 2,$(1))) + ( \ + echo -ne "\x00\x00\x00\x00\x00\x00\x00\x03" | \ + dd bs=42 count=1 conv=sync; \ + hw_id="$(hw_id)"; \ + echo -ne "\x$${hw_id:0:2}\x$${hw_id:2:2}\x$${hw_id:4:2}\x$${hw_id:6:2}" | \ + dd bs=20 count=1 conv=sync; \ + echo -ne "$$(printf '%08x' $$(stat -c%s $@) | fold -s2 | xargs -I {} echo \\x{} | tr -d '\n')" | \ + dd bs=8 count=1 conv=sync; \ + echo -ne "$$($(STAGING_DIR_HOST)/bin/mkhash md5 $@ | fold -s2 | xargs -I {} echo \\x{} | tr -d '\n')" | \ + dd bs=58 count=1 conv=sync; \ + ) > $(KDIR)/tmp/$(DEVICE_NAME).header + $(call Build/xor-image,-p $(xor_pattern) -x) + cat $(KDIR)/tmp/$(DEVICE_NAME).header $@ > $@.new + mv $@.new $@ +endef + define Device/ai-br100 DTS := AI-BR100 IMAGE_SIZE := 7936k @@ -327,6 +346,18 @@ define Device/hc5861 endef TARGET_DEVICES += hc5861 +define Device/iodata_wn-ac1167gr + DTS := WN-AC1167GR + DEVICE_TITLE := I-O DATA WN-AC1167GR + IMAGE_SIZE := 6864k + IMAGES += factory.bin + IMAGE/factory.bin := \ + $$(sysupgrade_bin) | check-size $$$$(IMAGE_SIZE) | \ + elx-header 01040016 8844A2D168B45A2D + DEVICE_PACKAGES := kmod-mt76x2 +endef +TARGET_DEVICES += iodata_wn-ac1167gr + define Device/kimax_u35wf DTS := U35WF IMAGE_SIZE := 16064k