From: Andy Fleming Date: Mon, 16 Feb 2009 15:40:20 +0000 (-0600) Subject: TQM85xx: Fix a couple warnings in TQM8548 build X-Git-Tag: v2009.03-rc1~55 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=e0c4fac79d4d74572ddd43f75e7189cecca8d0ad;p=oweals%2Fu-boot.git TQM85xx: Fix a couple warnings in TQM8548 build The ecm variable in sdram.c was being declared for all 8548, but only used by specific 8548 boards, so we make that variable require those specific boards, too The nand code was using an index "i" into a table, and then re-using "i" to set addresses for each upm. However, then it relied on the old value of i still being there to enable things. Changed the second "i" to "j" Signed-off-by: Andy Fleming --- diff --git a/board/tqc/tqm85xx/nand.c b/board/tqc/tqm85xx/nand.c index dea652dfd9..8133fdc40e 100644 --- a/board/tqc/tqm85xx/nand.c +++ b/board/tqc/tqm85xx/nand.c @@ -395,7 +395,7 @@ static void upmb_write (u_char addr, ulong val) */ static void nand_upm_setup (volatile ccsr_lbc_t *lbc) { - uint i; + uint i, j; uint or3 = CONFIG_SYS_OR3_PRELIM; uint clock = get_lbc_clock (); @@ -429,8 +429,8 @@ static void nand_upm_setup (volatile ccsr_lbc_t *lbc) /* Assign address of table */ nand_upm_patt = upm_freq_table[i].upm_patt; - for (i = 0; i < 64; i++) { - upmb_write (i, *nand_upm_patt); + for (j = 0; j < 64; j++) { + upmb_write (j, *nand_upm_patt); nand_upm_patt++; } diff --git a/board/tqc/tqm85xx/sdram.c b/board/tqc/tqm85xx/sdram.c index 2b3de4499b..6d73a88ab0 100644 --- a/board/tqc/tqm85xx/sdram.c +++ b/board/tqc/tqm85xx/sdram.c @@ -79,7 +79,9 @@ long int sdram_setup (int casl) volatile ccsr_ddr_t *ddr = (void *)(CONFIG_SYS_MPC85xx_DDR_ADDR); #ifdef CONFIG_TQM8548 volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR); +#if defined(CONFIG_TQM8548_AG) || defined(CONFIG_TQM8548_BE) volatile ccsr_local_ecm_t *ecm = (void *)(CONFIG_SYS_MPC85xx_ECM_ADDR); +#endif #else /* !CONFIG_TQM8548 */ unsigned long cfg_ddr_timing1; unsigned long cfg_ddr_mode;