From: Tom Rini Date: Wed, 10 May 2017 16:01:02 +0000 (-0400) Subject: ti816x: Enable ethernet support X-Git-Tag: v2017.07-rc3~27 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=de8203653f80eb77dc446dd3c67de2269ed03516;p=oweals%2Fu-boot.git ti816x: Enable ethernet support The ti816x SoC revision of the ethernet IP block is handled by the "davinci_emac" driver, rather than the "cpsw" driver as done by later members of the family. Enable the relevant plumbing. Signed-off-by: Sriramakrishnan Signed-off-by: Vitaly Wool Signed-off-by: Tom Rini --- diff --git a/arch/arm/include/asm/arch-am33xx/emac_defs.h b/arch/arm/include/asm/arch-am33xx/emac_defs.h new file mode 100644 index 0000000000..b5703f710f --- /dev/null +++ b/arch/arm/include/asm/arch-am33xx/emac_defs.h @@ -0,0 +1,38 @@ +/* + * Copyright (C) 2010 Texas Instruments + * + * Based on: + * + * ---------------------------------------------------------------------------- + * + * dm644x_emac.h + * + * TI DaVinci (DM644X) EMAC peripheral driver header for DV-EVM + * + * Copyright (C) 2005 Texas Instruments. + * + * ---------------------------------------------------------------------------- + * + * SPDX-License-Identifier: GPL-2.0+ + * + */ + +#ifndef _EMAC_DEFS_H_ +#define _EMAC_DEFS_H_ + +#ifdef CONFIG_TI816X +#define EMAC_BASE_ADDR (0x4A100000) +#define EMAC_WRAPPER_BASE_ADDR (0x4A100900) +#define EMAC_WRAPPER_RAM_ADDR (0x4A102000) +#define EMAC_MDIO_BASE_ADDR (0x4A100800) +#define EMAC_MDIO_BUS_FREQ (250000000UL) +#define EMAC_MDIO_CLOCK_FREQ (2000000UL) + +typedef volatile unsigned int dv_reg; +typedef volatile unsigned int *dv_reg_p; + +#define DAVINCI_EMAC_VERSION2 +#define DAVINCI_EMAC_GIG_ENABLE +#endif + +#endif /* _EMAC_DEFS_H_ */ diff --git a/arch/arm/include/asm/arch-am33xx/hardware_ti816x.h b/arch/arm/include/asm/arch-am33xx/hardware_ti816x.h index 3c680649ab..78b79486ed 100644 --- a/arch/arm/include/asm/arch-am33xx/hardware_ti816x.h +++ b/arch/arm/include/asm/arch-am33xx/hardware_ti816x.h @@ -31,6 +31,7 @@ /* Control Module Base Address */ #define CTRL_BASE 0x48140000 +#define CTRL_DEVICE_BASE 0x48140600 /* PRCM Base Address */ #define PRCM_BASE 0x48180000 diff --git a/board/ti/ti816x/evm.c b/board/ti/ti816x/evm.c index 577e60f875..9d6c3d6b5d 100644 --- a/board/ti/ti816x/evm.c +++ b/board/ti/ti816x/evm.c @@ -9,6 +9,7 @@ #include #include +#include #include #include #include @@ -31,6 +32,33 @@ int board_init(void) return 0; } +int board_eth_init(bd_t *bis) +{ + uint8_t mac_addr[6]; + uint32_t mac_hi, mac_lo; + struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE; + + if (!eth_getenv_enetaddr("ethaddr", mac_addr)) { + printf(" not set. Reading from E-fuse\n"); + /* try reading mac address from efuse */ + mac_lo = readl(&cdev->macid0l); + mac_hi = readl(&cdev->macid0h); + mac_addr[0] = mac_hi & 0xFF; + mac_addr[1] = (mac_hi & 0xFF00) >> 8; + mac_addr[2] = (mac_hi & 0xFF0000) >> 16; + mac_addr[3] = (mac_hi & 0xFF000000) >> 24; + mac_addr[4] = mac_lo & 0xFF; + mac_addr[5] = (mac_lo & 0xFF00) >> 8; + + if (is_valid_ethaddr(mac_addr)) + eth_setenv_enetaddr("ethaddr", mac_addr); + else + printf("Unable to read MAC address. Set \n"); + } + + return davinci_emac_initialize(); +} + #ifdef CONFIG_SPL_BUILD static struct module_pin_mux mmc_pin_mux[] = { { OFFSET(pincntl157), PULLDOWN_EN | PULLUDDIS | MODE(0x0) }, diff --git a/configs/ti816x_evm_defconfig b/configs/ti816x_evm_defconfig index 1c6608218b..7f43ecb7eb 100644 --- a/configs/ti816x_evm_defconfig +++ b/configs/ti816x_evm_defconfig @@ -35,6 +35,11 @@ CONFIG_OF_CONTROL=y CONFIG_DM=y CONFIG_DM_GPIO=y CONFIG_DM_I2C=y +CONFIG_CMD_DHCP=y +CONFIG_CMD_MII=y +CONFIG_CMD_PING=y +CONFIG_CMD_EXT2=y +CONFIG_CMD_FAT=y CONFIG_MMC_OMAP_HS=y CONFIG_SYS_NS16550=y # CONFIG_USE_PRIVATE_LIBGCC is not set diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c index 5e7ebc8a99..d1024879a0 100644 --- a/drivers/net/davinci_emac.c +++ b/drivers/net/davinci_emac.c @@ -341,6 +341,14 @@ static int gen_auto_negotiate(int phy_addr) if (!davinci_eth_phy_read(phy_addr, MII_BMCR, &tmp)) return(0); +#ifdef DAVINCI_EMAC_GIG_ENABLE + davinci_eth_phy_read(phy_addr, MII_CTRL1000, &val); + val |= PHY_1000BTCR_1000FD; + val &= ~PHY_1000BTCR_1000HD; + davinci_eth_phy_write(phy_addr, MII_CTRL1000, val); + davinci_eth_phy_read(phy_addr, MII_CTRL1000, &val); +#endif + /* Restart Auto_negotiation */ tmp |= BMCR_ANRESTART; davinci_eth_phy_write(phy_addr, MII_BMCR, tmp); @@ -407,7 +415,8 @@ static void __attribute__((unused)) davinci_eth_gigabit_enable(int phy_addr) static int davinci_eth_open(struct eth_device *dev, bd_t *bis) { dv_reg_p addr; - u_int32_t clkdiv, cnt; + u_int32_t clkdiv, cnt, mac_control; + uint16_t __maybe_unused lpa_val; volatile emac_desc *rx_desc; int index; @@ -488,19 +497,6 @@ static int davinci_eth_open(struct eth_device *dev, bd_t *bis) /* Enable ch 0 only */ writel(1, &adap_emac->RXUNICASTSET); - /* Enable MII interface and Full duplex mode */ -#if defined(CONFIG_SOC_DA8XX) || \ - (defined(CONFIG_OMAP34XX) && defined(CONFIG_DRIVER_TI_EMAC_USE_RMII)) - writel((EMAC_MACCONTROL_MIIEN_ENABLE | - EMAC_MACCONTROL_FULLDUPLEX_ENABLE | - EMAC_MACCONTROL_RMIISPEED_100), - &adap_emac->MACCONTROL); -#else - writel((EMAC_MACCONTROL_MIIEN_ENABLE | - EMAC_MACCONTROL_FULLDUPLEX_ENABLE), - &adap_emac->MACCONTROL); -#endif - /* Init MDIO & get link state */ clkdiv = CONFIG_SYS_EMAC_TI_CLKDIV; writel((clkdiv & 0xff) | MDIO_CONTROL_ENABLE | MDIO_CONTROL_FAULT, @@ -513,8 +509,26 @@ static int davinci_eth_open(struct eth_device *dev, bd_t *bis) if (index == -1) return(0); - emac_gigabit_enable(active_phy_addr[index]); + /* Enable MII interface */ + mac_control = EMAC_MACCONTROL_MIIEN_ENABLE; +#ifdef DAVINCI_EMAC_GIG_ENABLE + davinci_eth_phy_read(active_phy_addr[index], MII_STAT1000, &lpa_val); + if (lpa_val & PHY_1000BTSR_1000FD) { + debug_emac("eth_open : gigabit negotiated\n"); + mac_control |= EMAC_MACCONTROL_FULLDUPLEX_ENABLE; + mac_control |= EMAC_MACCONTROL_GIGABIT_ENABLE; + } +#endif + davinci_eth_phy_read(active_phy_addr[index], MII_LPA, &lpa_val); + if (lpa_val & (LPA_100FULL | LPA_10FULL)) + /* set EMAC for Full Duplex */ + mac_control |= EMAC_MACCONTROL_FULLDUPLEX_ENABLE; +#if defined(CONFIG_SOC_DA8XX) || \ + (defined(CONFIG_OMAP34XX) && defined(CONFIG_DRIVER_TI_EMAC_USE_RMII)) + mac_control |= EMAC_MACCONTROL_RMIISPEED_100; +#endif + writel(mac_control, &adap_emac->MACCONTROL); /* Start receive process */ writel(BD_TO_HW((u_int32_t)emac_rx_desc), &adap_emac->RX0HDP); @@ -619,8 +633,6 @@ static int davinci_eth_send_packet (struct eth_device *dev, return (ret_status); } - emac_gigabit_enable(active_phy_addr[index]); - /* Check packet size and if < EMAC_MIN_ETHERNET_PKT_SIZE, pad it up */ if (length < EMAC_MIN_ETHERNET_PKT_SIZE) { length = EMAC_MIN_ETHERNET_PKT_SIZE; @@ -648,8 +660,6 @@ static int davinci_eth_send_packet (struct eth_device *dev, return (ret_status); } - emac_gigabit_enable(active_phy_addr[index]); - if (readl(&adap_emac->TXINTSTATRAW) & 0x01) { ret_status = length; break; @@ -870,11 +880,19 @@ int davinci_emac_initialize(void) retval = mdio_register(mdiodev); if (retval < 0) return retval; +#ifdef DAVINCI_EMAC_GIG_ENABLE +#define PHY_CONF_REG 22 + /* Enable PHY to clock out TX_CLK */ + davinci_eth_phy_read(active_phy_addr[i], PHY_CONF_REG, &tmp); + tmp |= PHY_CONF_TXCLKEN; + davinci_eth_phy_write(active_phy_addr[i], PHY_CONF_REG, tmp); + davinci_eth_phy_read(active_phy_addr[i], PHY_CONF_REG, &tmp); +#endif } -#if defined(CONFIG_DRIVER_TI_EMAC_USE_RMII) && \ +#if defined(CONFIG_TI816X) || (defined(CONFIG_DRIVER_TI_EMAC_USE_RMII) && \ defined(CONFIG_MACH_DAVINCI_DA850_EVM) && \ - !defined(CONFIG_DRIVER_TI_EMAC_RMII_NO_NEGOTIATE) + !defined(CONFIG_DRIVER_TI_EMAC_RMII_NO_NEGOTIATE)) for (i = 0; i < num_phy; i++) { if (phy[i].is_phy_connected(i)) phy[i].auto_negotiate(i); diff --git a/drivers/net/davinci_emac.h b/drivers/net/davinci_emac.h index 13cd68f040..e2ed54bac5 100644 --- a/drivers/net/davinci_emac.h +++ b/drivers/net/davinci_emac.h @@ -40,6 +40,8 @@ /* MII Status Register */ #define MII_STATUS_REG 1 +/* PHY Configuration register */ +#define PHY_CONF_TXCLKEN (1 << 5) /* Number of statistics registers */ #define EMAC_NUM_STATS 36 diff --git a/include/configs/ti816x_evm.h b/include/configs/ti816x_evm.h index defcad4518..4a81b1daf8 100644 --- a/include/configs/ti816x_evm.h +++ b/include/configs/ti816x_evm.h @@ -123,6 +123,15 @@ #define CONFIG_SYS_TEXT_BASE 0x80800000 +#define CONFIG_DRIVER_TI_EMAC +#define CONFIG_MII +#define CONFIG_BOOTP_DNS +#define CONFIG_BOOTP_DNS2 +#define CONFIG_BOOTP_SEND_HOSTNAME +#define CONFIG_BOOTP_GATEWAY +#define CONFIG_BOOTP_SUBNETMASK +#define CONFIG_NET_RETRY_COUNT 10 + /* Since SPL did pll and ddr initialization for us, * we don't need to do it twice. */