From: Haiying Wang <Haiying.Wang@freescale.com>
Date: Tue, 19 Jun 2007 18:18:32 +0000 (-0400)
Subject: Empirically set cpo and clk_adjust for mpc85xx DDR2 support
X-Git-Tag: v1.3.0-rc1~19^2~22^2~4
X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=d111d6382c99fdea08c2312eeeae8786945e189a;p=oweals%2Fu-boot.git

Empirically set cpo and clk_adjust for mpc85xx DDR2 support

This patch is against u-boot-mpc85xx.git of www.denx.com

Setting cpo to 0x9 for frequencies higher than 333MHz is verified on
both MPC8548CDS board and MPC8568MDS board, especially for supporting
533MHz DDR2.

Setting clk_adjust to 0x6(3/4 late cycle) for MPC8568MDS board is for
DDR2 on all current board versions especially ver 1.92 or later to bring
up.

Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
---

diff --git a/cpu/mpc85xx/spd_sdram.c b/cpu/mpc85xx/spd_sdram.c
index 679f3608f7..5dc223a53e 100644
--- a/cpu/mpc85xx/spd_sdram.c
+++ b/cpu/mpc85xx/spd_sdram.c
@@ -692,13 +692,10 @@ spd_sdram(void)
 	 */
 	cpo = 0;
 	if (spd.mem_type == SPD_MEMTYPE_DDR2) {
-		if (effective_data_rate == 266 || effective_data_rate == 333) {
+		if (effective_data_rate <= 333) {
 			cpo = 0x7;		/* READ_LAT + 5/4 */
-		} else if (effective_data_rate == 400) {
-			cpo = 0x9;		/* READ_LAT + 7/4 */
 		} else {
-			/* Pure speculation */
-			cpo = 0xb;
+			cpo = 0x9;		/* READ_LAT + 7/4 */
 		}
 	}
 
@@ -905,7 +902,12 @@ spd_sdram(void)
 	if (spd.mem_type == SPD_MEMTYPE_DDR)
 		clk_adjust = 0x6;
 	else
+#ifdef CONFIG_MPC8568
+		/* Empirally setting clk_adjust */
+		clk_adjust = 0x6;
+#else
 		clk_adjust = 0x7;
+#endif
 
 	ddr->sdram_clk_cntl = (0
 			       | 0x80000000