From: Marek Vasut Date: Thu, 11 Jul 2013 23:03:04 +0000 (+0200) Subject: net: fec: Avoid MX28 bus sync issue X-Git-Tag: v2013.07-rc3~4^2^2~6 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=ab94cd491faf3e7b0a3b934f5817b15997bcb315;p=oweals%2Fu-boot.git net: fec: Avoid MX28 bus sync issue The MX28 multi-layer AHB bus can be too slow and trigger the FEC DMA too early, before all the data hit the DRAM. This patch ensures the data are written in the RAM before the DMA starts. Please see the comment in the patch for full details. This patch was produced with an amazing help from Albert Aribaud, who pointed out it can possibly be such a bus synchronisation issue. Signed-off-by: Marek Vasut Cc: Albert ARIBAUD Cc: Fabio Estevam Cc: Stefano Babic Tested-by: Fabio Estevam Tested-by: Alexandre Pereira da Silva --- diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index 97bf8fe17d..ec5b9db660 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -736,6 +736,28 @@ static int fec_send(struct eth_device *dev, void *packet, int length) addr = (uint32_t)fec->tbd_base; flush_dcache_range(addr, addr + size); + /* + * Below we read the DMA descriptor's last four bytes back from the + * DRAM. This is important in order to make sure that all WRITE + * operations on the bus that were triggered by previous cache FLUSH + * have completed. + * + * Otherwise, on MX28, it is possible to observe a corruption of the + * DMA descriptors. Please refer to schematic "Figure 1-2" in MX28RM + * for the bus structure of MX28. The scenario is as follows: + * + * 1) ARM core triggers a series of WRITEs on the AHB_ARB2 bus going + * to DRAM due to flush_dcache_range() + * 2) ARM core writes the FEC registers via AHB_ARB2 + * 3) FEC DMA starts reading/writing from/to DRAM via AHB_ARB3 + * + * Note that 2) does sometimes finish before 1) due to reordering of + * WRITE accesses on the AHB bus, therefore triggering 3) before the + * DMA descriptor is fully written into DRAM. This results in occasional + * corruption of the DMA descriptor. + */ + readl(addr + size - 4); + /* * Enable SmartDMA transmit task */