From: benoit.thebaudeau@advans Date: Thu, 19 Jul 2012 02:12:46 +0000 (+0000) Subject: net: fec_mxc: Fix setting of RCR for xMII X-Git-Tag: v2012.10-rc1~415^2~35^2~7 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=9d2d924a0a728a4f852a3e9de7aa6cc72c4b460d;p=oweals%2Fu-boot.git net: fec_mxc: Fix setting of RCR for xMII At least on i.MX25, the RMII mode did not work, which is fixed by this patch. The MII_MODE bit of the FEC RCR register means xMII, i.e. 'not 7-wire', so set it accordingly. According to the xMII and 7-wire (aka GPSI) standards, full duplex should be available on xMII, but not on 7-wire, so set FCE accordingly. The FEC may support full duplex for 7-wire too, but the reference manual does not say that, so avoid an invalid assumption. Actually, the choice between half and full duplex also depends on the endpoint/switch/repeater configuration, so a config option could be added for that, but there has been no need for it so far. Signed-off-by: Benoît Thébaudeau Cc: Joe Hershberger Cc: Stefano Babic --- diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index 5700552189..ddbdd3336f 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -424,14 +424,12 @@ static void fec_reg_setup(struct fec_priv *fec) /* Start with frame length = 1518, common for all modes. */ rcntrl = PKTSIZE << FEC_RCNTRL_MAX_FL_SHIFT; - if (fec->xcv_type == SEVENWIRE) - rcntrl |= FEC_RCNTRL_FCE; - else if (fec->xcv_type == RGMII) + if (fec->xcv_type != SEVENWIRE) /* xMII modes */ + rcntrl |= FEC_RCNTRL_FCE | FEC_RCNTRL_MII_MODE; + if (fec->xcv_type == RGMII) rcntrl |= FEC_RCNTRL_RGMII; else if (fec->xcv_type == RMII) rcntrl |= FEC_RCNTRL_RMII; - else /* MII mode */ - rcntrl |= FEC_RCNTRL_FCE | FEC_RCNTRL_MII_MODE; writel(rcntrl, &fec->eth->r_cntrl); }