From: Tim Harvey Date: Tue, 24 May 2016 18:03:53 +0000 (-0700) Subject: imx: ventana: export backlight gpio after gpio driver is available X-Git-Tag: v2016.07-rc2~16^2~26 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=78532623303e089e7d36b3a11d293e618b927655;p=oweals%2Fu-boot.git imx: ventana: export backlight gpio after gpio driver is available Calling request_gpio to register bklt_gpio with the GPIO driver had no effect in setup_display called from early board init (although pinmuxing it and configuring it as output-low does do what it should). Therefore move the request_gpio later in enable_lvds so that its registered for use by the gpio command if LVDS is actually enabled. Signed-off-by: Tim Harvey --- diff --git a/board/gateworks/gw_ventana/gw_ventana.c b/board/gateworks/gw_ventana/gw_ventana.c index 3b7c82b1dc..7a3d96a039 100644 --- a/board/gateworks/gw_ventana/gw_ventana.c +++ b/board/gateworks/gw_ventana/gw_ventana.c @@ -317,6 +317,8 @@ static void enable_lvds(struct display_info_t const *dev) writel(reg, &iomux->gpr[2]); /* Enable Backlight */ + gpio_request(IMX_GPIO_NR(1, 10), "bklt_gpio"); + gpio_direction_output(IMX_GPIO_NR(1, 10), 0); gpio_request(IMX_GPIO_NR(1, 18), "bklt_en"); SETUP_IOMUX_PAD(PAD_SD1_CMD__GPIO1_IO18 | DIO_PAD_CFG); gpio_direction_output(IMX_GPIO_NR(1, 18), 1); @@ -456,8 +458,7 @@ static void setup_display(void) <gpr[3]); - /* Backlight CABEN on LVDS connector */ - gpio_request(IMX_GPIO_NR(1, 10), "bklt_gpio"); + /* LVDS Backlight GPIO on LVDS connector - output low */ SETUP_IOMUX_PAD(PAD_SD2_CLK__GPIO1_IO10 | DIO_PAD_CFG); gpio_direction_output(IMX_GPIO_NR(1, 10), 0); }