From: ahaslam@baylibre.com Date: Mon, 13 Feb 2017 17:49:40 +0000 (+0100) Subject: da850: Add instructions to copy AIS image to an MMC card X-Git-Tag: v2017.03-rc3~13 X-Git-Url: https://git.librecmc.org/?a=commitdiff_plain;h=4aac44be11a44b72a87de2ee751aa1fcd4960fef;p=oweals%2Fu-boot.git da850: Add instructions to copy AIS image to an MMC card The da850 soc's can boot from a external mmc card, but the AIS image should be written to the correct sector. Add instructions to copy the AIS image to a MMC card. Signed-off-by: Axel Haslam Reviewed-by: Tom Rini --- diff --git a/board/davinci/da8xxevm/README.da850 b/board/davinci/da8xxevm/README.da850 index 313a1ef431..29cb4ec408 100644 --- a/board/davinci/da8xxevm/README.da850 +++ b/board/davinci/da8xxevm/README.da850 @@ -47,6 +47,29 @@ U-Boot > sf erase 0 +320000 U-Boot > tftp u-boot.ais U-Boot > sf write c0700000 0 $filesize +Flashing the images to MMC +========================== +If the boot pins are set to boot from mmc, the RBL will try to load the +next boot stage form the first couple of sectors of an external mmc card. +As sector 0 is usually used for storing the partition information, the +AIS image should be written at least after the first sector, but before the +first partition begins. (e.g: make sure to leave at least 500KB of unallocated +space at the start of the mmc when creating the partitions) + +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR is used by SPL, and should +point to the sector were the u-boot image is located. (eg. After SPL) + +There are 2 ways to copy the AIS image to the mmc card: + + 1 - Using the TI tool "uflash" + $ uflash -d /dev/mmcblk0 -b ./u-boot.ais -p OMAPL138 -vv + + 2 - using the "dd" command + $ dd if=u-boot.ais of=/dev/mmcblk0 seek=117 bs=512 conv=fsync + +uflash writes the AIS image at offset 117. For compatibility with uflash, +CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR is set to take into account this +offset, and the dd command is adjusted accordingly. Recovery ========