Based on commit
980066e6d964 ("dt-bindings: phy: dp83867: Add documentation
for disabling clock output") of mainline linux kernel.
The clock output is generally only used for testing and development and not
used to daisy-chain PHYs. It's just a source of RF noise afterward.
Add a mux value for "off". I've added it as another enumeration to the
output property. In the actual PHY, the mux and the output enable are
independently controllable. However, it doesn't seem useful to be able
to describe the mux setting when the output is disabled.
Document that PHY's default setting will be left as is if the property
is omitted.
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
compensate for the board being designed with the lanes swapped.
- enet-phy-no-lane-swap - Indicates that PHY will disable swap of the
TX/RX lanes.
- - ti,clk-output-sel - Clock output select - see dt-bindings/net/ti-dp83867.h
- for applicable values
+ - ti,clk-output-sel - Muxing option for CLK_OUT pin. See dt-bindings/net/ti-dp83867.h
+ for applicable values. The CLK_OUT pin can also
+ be disabled by this property. When omitted, the
+ PHY's default will be left as is.
Default child nodes are standard Ethernet PHY device
nodes as described in doc/devicetree/bindings/net/ethernet.txt
#define DP83867_CLK_O_SEL_CHN_C_TCLK 0xA
#define DP83867_CLK_O_SEL_CHN_D_TCLK 0xB
#define DP83867_CLK_O_SEL_REF_CLK 0xC
-
+/* Special flag to indicate clock should be off */
+#define DP83867_CLK_O_SEL_OFF 0xFFFFFFFF
#endif