NAND: Remove ONFI detection message to from bootup log

Without this patch, boot shows this messages upon NAND detection:

NAND:  ONFI flash detected
ONFI param page 0 valid
ONFI flash detected
ONFI param page 0 valid
128 MiB

With this patch, its back to the U-Boot "standard":

NAND:  128 MiB

Tested on x600 (SPEAr600).

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Amit Virdi <amit.virdi@st.com>
Cc: Vipin Kumar <vipin.kumar@st.com>
Cc: Scott Wood <scottwood@freescale.com>
Acked-by: Amit Virdi <amit.virdi@st.com>
Signed-off-by: Scott Wood <scott@tyr.buserror.net>

diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index bef79bed0fe1563489a85ed9ecaa69ed25805304..bfd668fa0ac5425f21361971ca5f0efc26bff4f7 100644 (file)
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -2530,13 +2530,14 @@ static int nand_flash_detect_onfi(struct mtd_info *mtd, struct nand_chip *chip,
                chip->read_byte(mtd) != 'F' || chip->read_byte(mtd) != 'I')
                return 0;
 
-       printk(KERN_INFO "ONFI flash detected\n");
+       MTDDEBUG(MTD_DEBUG_LEVEL0, "ONFI flash detected\n");
        chip->cmdfunc(mtd, NAND_CMD_PARAM, 0, -1);
        for (i = 0; i < 3; i++) {
                chip->read_buf(mtd, (uint8_t *)p, sizeof(*p));
                if (onfi_crc16(ONFI_CRC_BASE, (uint8_t *)p, 254) ==
                                le16_to_cpu(p->crc)) {
-                       printk(KERN_INFO "ONFI param page %d valid\n", i);
+                       MTDDEBUG(MTD_DEBUG_LEVEL0,
+                                "ONFI param page %d valid\n", i);
                        break;
                }
        }