mx6memcal: Fix the UART ports for mx6sabresd/auto boards
authorFabio Estevam <fabio.estevam@nxp.com>
Wed, 3 Jan 2018 14:55:34 +0000 (12:55 -0200)
committerStefano Babic <sbabic@denx.de>
Fri, 12 Jan 2018 13:28:04 +0000 (14:28 +0100)
mx6sabresd board uses the following pins for console:

PAD_CSI0_DAT10__UART1_TX_DATA
PAD_CSI0_DAT11__UART1_RX_DATA

,so put it in the same config option as wandboard.

mx6sabreauto board uses the following pins for console:

PAD_KEY_COL0__UART4_TX_DATA
PAD_KEY_ROW0__UART4_RX_DATA

So do not mention sabreauto board as part of the UART1_SD3_DAT6_7 option.

The config option for sabreauto can be added later when needed.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
board/freescale/mx6memcal/Kconfig

index 443804dc11ca8f25c815b2c4278c8878eed23eab..9987cba5dcb7aa3962200d55cc148d18b8f40734 100644 (file)
@@ -45,20 +45,12 @@ choice
                  NXP SABRELite.
 
        config UART1_CSI0_DAT10_11
-               bool "UART1 on CSI0_DAT10/11 (Wand)"
+               bool "UART1 on CSI0_DAT10/11 (Wand, SabreSD)"
                depends on SERIAL_CONSOLE_UART1
                help
                  Choose this configuration if you're using pads
                  CSI0_DAT10 and DAT11 for a console on UART1 as
-                 is done on the i.MX6 Wand board.
-
-       config UART1_SD3_DAT6_7
-               bool "UART1 on SD3_DAT6/7 (SabreSD, SabreAuto)"
-               depends on SERIAL_CONSOLE_UART1
-               help
-                 Choose this configuration if you're using pads
-                 SD3_DAT6 and DAT7 for a console on UART1 as is
-                 done on the NXP SABRESD or SABREAUTO designs.
+                 is done on the i.MX6 Wand board and i.MX6 SabreSD.
 
        config UART1_UART1
                bool "UART1 on UART1 (i.MX6SL EVK, WaRP)"