OMAP3: pandora: fix booting without serial attached

When the board is booted without serial cable attached (which
is how most of them will be used) UART RX is left floating and
sometimes picks noise, which interrupts countdown and enters
U-Boot prompt instead of booting the kernel.

Fix this by setting up internal pullup on UART RX pin. This
does not prevent serial from working as the internal pullup
is weak.

Signed-off-by: Grazvydas Ignotas <notasas@gmail.com>

diff --git a/board/pandora/pandora.h b/board/pandora/pandora.h
index 5bfa0f9e26769f61c0dfa886af7a176641bcf7b6..f0ad16b0a407345cf9497fb8d1bd878c193198d4 100644 (file)
--- a/board/pandora/pandora.h
+++ b/board/pandora/pandora.h
@@ -219,7 +219,8 @@ const omap3_sysinfo sysinfo = {
        MUX_VAL(CP(UART2_RX),           (IEN  | PTD | EN  | M4)) /*GPIO_147,*/\
                                                                 /*UART2_RX*/\
  /*Serial Interface (Peripheral boot, Linux console, on AV connector)*/\
-       MUX_VAL(CP(UART3_RX_IRRX),      (IEN  | PTD | DIS | M0)) /*UART3_RX*/\
+ /*RX pulled up to avoid noise when nothing is connected to serial port*/\
+       MUX_VAL(CP(UART3_RX_IRRX),      (IEN  | PTU | EN  | M0)) /*UART3_RX*/\
        MUX_VAL(CP(UART3_TX_IRTX),      (IDIS | PTD | DIS | M0)) /*UART3_TX*/\
  /*LEDs (Controlled by OMAP)*/\
        MUX_VAL(CP(MMC1_DAT6),          (IDIS | PTD | DIS | M4)) /*GPIO_128*/\