nitrogen6x: display: add wvga-lvds panel

Add support for WVGA (800x480) panels using VESA GTF timings over
LVDS.

No auto-detection is supported, so you must configure this panel
manually through the 'panel' environment variable:

        U-Boot > setenv panel svga
        U-Boot > saveenv && reset

Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com>

diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c
index 38d0b529decbf6a4254f52bcba0b417d683a833e..a82ec45b0ff76c1d18c02ea53e6a3abf6bcaaef5 100644 (file)
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -673,6 +673,26 @@ struct display_info_t const displays[] = {{
                .vsync_len      = 10,
                .sync           = FB_SYNC_EXT,
                .vmode          = FB_VMODE_NONINTERLACED
+} }, {
+       .bus    = 0,
+       .addr   = 0,
+       .pixfmt = IPU_PIX_FMT_LVDS666,
+       .detect = 0,
+       .enable = enable_lvds,
+       .mode   = {
+               .name           = "wvga-lvds",
+               .refresh        = 57,
+               .xres           = 800,
+               .yres           = 480,
+               .pixclock       = 15385,
+               .left_margin    = 220,
+               .right_margin   = 40,
+               .upper_margin   = 21,
+               .lower_margin   = 7,
+               .hsync_len      = 60,
+               .vsync_len      = 10,
+               .sync           = FB_SYNC_EXT,
+               .vmode          = FB_VMODE_NONINTERLACED
 } }, {
        .bus    = 2,
        .addr   = 0x48,