spi: cadence_qspi_apb: Use 32 bit indirect read transaction when possible
authorVignesh R <vigneshr@ti.com>
Wed, 21 Dec 2016 05:12:33 +0000 (10:42 +0530)
committerJagan Teki <jagan@openedev.com>
Wed, 4 Jan 2017 15:38:35 +0000 (16:38 +0100)
According to Section 11.15.4.9.1 Indirect Read Controller of K2G SoC
TRM SPRUHY8D[1], the external master is only permitted to issue 32-bit
data interface reads until the last word of an indirect transfer
So, make sure that QSPI indirect reads are 32 bit sized except for the
final read. If the rxbuf is unaligned then use bounce buffer, so that
readsl() can be used instead of readsb() to avoid non 32-bit accesses.

[1]www.ti.com/lit/ug/spruhy8d/spruhy8d.pdf

Signed-off-by: Vignesh R <vigneshr@ti.com>
Reviewed-by: Marek Vasut <marex@denx.de>
Reviewed-by: Jagan Teki <jagan@openedev.com>
drivers/spi/cadence_qspi_apb.c

index 5d5b6f0d350b6cc58dd196dd0ed9ff361ce7fd6e..e02f2217f45f55c3c67da247d5b0a1332d026ff9 100644 (file)
@@ -634,6 +634,8 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
 {
        unsigned int remaining = n_rx;
        unsigned int bytes_to_read = 0;
+       struct bounce_buffer bb;
+       u8 *bb_rxbuf;
        int ret;
 
        writel(n_rx, plat->regbase + CQSPI_REG_INDIRECTRDBYTES);
@@ -642,6 +644,11 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
        writel(CQSPI_REG_INDIRECTRD_START,
               plat->regbase + CQSPI_REG_INDIRECTRD);
 
+       ret = bounce_buffer_start(&bb, (void *)rxbuf, n_rx, GEN_BB_WRITE);
+       if (ret)
+               return ret;
+       bb_rxbuf = bb.bounce_buffer;
+
        while (remaining > 0) {
                ret = cadence_qspi_wait_for_data(plat);
                if (ret < 0) {
@@ -655,12 +662,13 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
                        bytes_to_read *= CQSPI_FIFO_WIDTH;
                        bytes_to_read = bytes_to_read > remaining ?
                                        remaining : bytes_to_read;
-                       /* Handle non-4-byte aligned access to avoid data abort. */
-                       if (((uintptr_t)rxbuf % 4) || (bytes_to_read % 4))
-                               readsb(plat->ahbbase, rxbuf, bytes_to_read);
-                       else
-                               readsl(plat->ahbbase, rxbuf, bytes_to_read >> 2);
-                       rxbuf += bytes_to_read;
+                       readsl(plat->ahbbase, bb_rxbuf, bytes_to_read >> 2);
+                       if (bytes_to_read % 4)
+                               readsb(plat->ahbbase,
+                                      bb_rxbuf + rounddown(bytes_to_read, 4),
+                                      bytes_to_read % 4);
+
+                       bb_rxbuf += bytes_to_read;
                        remaining -= bytes_to_read;
                        bytes_to_read = cadence_qspi_get_rd_sram_level(plat);
                }
@@ -677,6 +685,7 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
        /* Clear indirect completion status */
        writel(CQSPI_REG_INDIRECTRD_DONE,
               plat->regbase + CQSPI_REG_INDIRECTRD);
+       bounce_buffer_stop(&bb);
 
        return 0;
 
@@ -684,6 +693,7 @@ failrd:
        /* Cancel the indirect read */
        writel(CQSPI_REG_INDIRECTRD_CANCEL,
               plat->regbase + CQSPI_REG_INDIRECTRD);
+       bounce_buffer_stop(&bb);
        return ret;
 }