i2c: designware: Avoid overwriting the cmd_data register
authorMarek Vasut <marex@denx.de>
Thu, 20 Oct 2016 14:48:28 +0000 (16:48 +0200)
committerHeiko Schocher <hs@denx.de>
Mon, 24 Oct 2016 16:15:47 +0000 (18:15 +0200)
Make sure the driver writes the cmd_data register only once per
read transfer instead of doing so potentially repeatedly.

In case the read transfer didn't finish quickly enough, the loop
in the driver code would spin fast enough to write the same value
into the cmd_data register again before re-checking whether the
transfer completed, which would cause another spurious read transfer
on the bus.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Stefan Roese <sr@denx.de>
Cc: Alexey Brodkin <abrodkin@synopsys.com>
Cc: Heiko Schocher <hs@denx.de>
Cc: Dinh Nguyen <dinguyen@opensource.altera.com>
Cc: Chin Liang See <clsee@altera.com>
drivers/i2c/designware_i2c.c

index e60fd0a41903b811a98f0bcc88bf6ac8ae9519de..c68ff6420b283535840673d9a37539d4830f2523 100644 (file)
@@ -249,6 +249,7 @@ static int __dw_i2c_read(struct i2c_regs *i2c_base, u8 dev, uint addr,
                         int alen, u8 *buffer, int len)
 {
        unsigned long start_time_rx;
+       unsigned int active = 0;
 
 #ifdef CONFIG_SYS_I2C_EEPROM_ADDR_OVERFLOW
        /*
@@ -274,18 +275,28 @@ static int __dw_i2c_read(struct i2c_regs *i2c_base, u8 dev, uint addr,
 
        start_time_rx = get_timer(0);
        while (len) {
-               if (len == 1)
-                       writel(IC_CMD | IC_STOP, &i2c_base->ic_cmd_data);
-               else
-                       writel(IC_CMD, &i2c_base->ic_cmd_data);
+               if (!active) {
+                       /*
+                        * Avoid writing to ic_cmd_data multiple times
+                        * in case this loop spins too quickly and the
+                        * ic_status RFNE bit isn't set after the first
+                        * write. Subsequent writes to ic_cmd_data can
+                        * trigger spurious i2c transfer.
+                        */
+                       if (len == 1)
+                               writel(IC_CMD | IC_STOP, &i2c_base->ic_cmd_data);
+                       else
+                               writel(IC_CMD, &i2c_base->ic_cmd_data);
+                       active = 1;
+               }
 
                if (readl(&i2c_base->ic_status) & IC_STATUS_RFNE) {
                        *buffer++ = (uchar)readl(&i2c_base->ic_cmd_data);
                        len--;
                        start_time_rx = get_timer(0);
-
+                       active = 0;
                } else if (get_timer(start_time_rx) > I2C_BYTE_TO) {
-                               return 1;
+                       return 1;
                }
        }