move RTC_RX8025 to Kconfig and fixup board configs.
Signed-off-by: Heiko Schocher <hs@denx.de>
CONFIG_FLASH_CFI_DRIVER=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_E1000=y
+CONFIG_RTC_RX8025=y
CONFIG_BAUDRATE=9600
CONFIG_SYS_NS16550=y
CONFIG_OF_LIBFDT=y
CONFIG_PHY_MARVELL=y
CONFIG_MII=y
CONFIG_TSEC_ENET=y
+CONFIG_RTC_RX8025=y
CONFIG_SYS_NS16550=y
CONFIG_USB=y
# CONFIG_USB_EHCI_HCD is not set
CONFIG_SYS_FLASH_CFI=y
CONFIG_PHY_MARVELL=y
CONFIG_TSEC_ENET=y
+CONFIG_RTC_RX8025=y
CONFIG_BAUDRATE=9600
CONFIG_SYS_NS16550=y
CONFIG_OF_LIBFDT=y
help
Support for Epson RX8010SJ Real Time Clock devices.
+config RTC_RX8025
+ bool "Enable RX8025 driver"
+ help
+ Support for Epson RX8025 Real Time Clock devices.
+
config RTC_PL031
bool "Enable ARM AMBA PL031 RTC driver"
help
*/
#define CONFIG_SYS_RTC_BUS_NUM 0x01
#define CONFIG_SYS_I2C_RTC_ADDR 0x32
-#define CONFIG_RTC_RX8025
/* Pass Ethernet MAC to VxWorks */
#define CONFIG_SYS_VXWORKS_MAC_PTR 0x000043f0
#define CONFIG_SYS_FSL_I2C2_OFFSET 0x3100
/* I2C RTC */
-#define CONFIG_RTC_RX8025 /* Use Epson rx8025 rtc via i2c */
#define CONFIG_SYS_I2C_RTC_ADDR 0x32 /* at address 0x32 */
/* I2C W83782G HW-Monitoring IC */
*/
#define CONFIG_SYS_RTC_BUS_NUM 0x01
#define CONFIG_SYS_I2C_RTC_ADDR 0x32
-#define CONFIG_RTC_RX8025
/* Pass Ethernet MAC to VxWorks */
#define CONFIG_SYS_VXWORKS_MAC_PTR 0x000043f0
CONFIG_RTC_MXS
CONFIG_RTC_PCF8563
CONFIG_RTC_PT7C4338
-CONFIG_RTC_RX8025
CONFIG_RUN_FROM_DDR0
CONFIG_RUN_FROM_DDR1
CONFIG_RUN_FROM_IRAM_ONLY