interrupts = <0 131 0>;
};
- gpio: gpio {
- gpio-controller;
- #gpio-cells = <2>;
-
- interrupt-controller;
- #interrupt-cells = <2>;
- };
};
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
- cd-gpios = <&gpio 0xA2 0>;
+ cd-gpios = <&gpk2 2 0>;
};
sdhci@12540000 {
sdhci@12510000 {
samsung,bus-width = <8>;
samsung,timing = <1 3 3>;
- pwr-gpios = <&gpio 146 0>;
+ pwr-gpios = <&gpk0 2 0>;
};
sdhci@12520000 {
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
- cd-gpios = <&gpio 284 0>;
+ cd-gpios = <&gpx3 4 0>;
};
sdhci@12540000 {
sdhci@12510000 {
samsung,bus-width = <8>;
samsung,timing = <1 3 3>;
- pwr-gpios = <&gpio 146 0>;
+ pwr-gpios = <&gpk0 2 0>;
};
sdhci@12520000 {
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
- cd-gpios = <&gpio 284 0>;
+ cd-gpios = <&gpx3 4 0>;
};
sdhci@12540000 {
soft-spi {
compatible = "u-boot,soft-spi";
- cs-gpio = <&gpio 235 0>; /* Y43 */
- sclk-gpio = <&gpio 225 0>; /* Y31 */
- mosi-gpio = <&gpio 227 0>; /* Y33 */
- miso-gpio = <&gpio 224 0>; /* Y30 */
+ cs-gpio = <&gpy4 3 0>;
+ sclk-gpio = <&gpy3 1 0>;
+ mosi-gpio = <&gpy3 3 0>;
+ miso-gpio = <&gpy3 0 0>;
spi-delay-us = <1>;
#address-cells = <1>;
#size-cells = <0>;
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
- cd-gpios = <&gpio 122 0>;
+ cd-gpios = <&gpk2 2 0>;
};
sdhci@12540000 {
sdhci@12510000 {
samsung,bus-width = <8>;
samsung,timing = <1 3 3>;
- pwr-gpios = <&gpio 0x6a 0>;
+ pwr-gpios = <&gpk0 4 0>;
status = "disabled";
};
sdhci@12530000 {
samsung,bus-width = <4>;
samsung,timing = <1 2 3>;
- cd-gpios = <&gpio 0x7a 0>;
+ cd-gpios = <&gpk2 2 0>;
};
sdhci@12540000 {
dwmmc@12550000 {
samsung,bus-width = <8>;
samsung,timing = <2 1 0>;
- pwr-gpios = <&gpio 0x6a 0>;
+ pwr-gpios = <&gpk0 4 0>;
fifoth_val = <0x203f0040>;
bus_hz = <400000000>;
div = <0x3>;
*/
#include "skeleton.dtsi"
+#include <dt-bindings/gpio/gpio.h>
/ {
compatible = "samsung,exynos5";
u-boot,dm-pre-reloc;
id = <3>;
};
-
- gpio: gpio {
- };
};
};
ehci@12110000 {
- samsung,vbus-gpio = <&gpio 0x316 0>; /* X26 */
+ samsung,vbus-gpio = <&gpx2 6 GPIO_ACTIVE_HIGH>;
};
};
reg = <0x1e>;
compatible = "google,cros-ec";
i2c-max-frequency = <100000>;
- ec-interrupt = <&gpio 182 1>;
+ ec-interrupt = <&gpx1 6 GPIO_ACTIVE_LOW>;
};
power-regulator@48 {
reg = <0>;
compatible = "google,cros-ec";
spi-max-frequency = <5000000>;
- ec-interrupt = <&gpio 182 1>;
+ ec-interrupt = <&gpx1 6 GPIO_ACTIVE_LOW>;
optimise-flash-write;
status = "disabled";
};
sound@3830000 {
samsung,codec-type = "max98095";
- codec-enable-gpio = <&gpio 0xb7 0>;
+ codec-enable-gpio = <&gpx1 7 GPIO_ACTIVE_HIGH>;
};
sound@12d60000 {
};
ehci@12110000 {
- samsung,vbus-gpio = <&gpio 0xb1 0>; /* X11 */
+ samsung,vbus-gpio = <&gpx1 1 GPIO_ACTIVE_HIGH>;
};
xhci@12000000 {
- samsung,vbus-gpio = <&gpio 0xbf 0>; /* X27 */
+ samsung,vbus-gpio = <&gpx2 7 GPIO_ACTIVE_HIGH>;
};
tmu@10060000 {
"google,peach", "samsung,exynos5420", "samsung,exynos5";
config {
- google,bad-wake-gpios = <&gpio 0x56 0>; /* gpx0-6 */
+ google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
hwid = "PIT TEST A-A 7848";
lazy-init = <1>;
};
spi-half-duplex;
spi-max-timeout-ms = <1100>;
spi-frame-header = <0xec>;
- ec-interrupt = <&gpio 93 1>; /* GPX1_5 */
+ ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
/*
* This describes the flash memory within the EC. Note
};
xhci@12000000 {
- samsung,vbus-gpio = <&gpio 0x40 0>; /* H00 */
+ samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
};
xhci@12400000 {
- samsung,vbus-gpio = <&gpio 0x41 0>; /* H01 */
+ samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
};
fimd@14400000 {
};
ehci@12110000 {
- samsung,vbus-gpio = <&gpio 0x66 0>; /* X26 */
+ samsung,vbus-gpio = <&gpx2 6 GPIO_ACTIVE_HIGH>;
};
serial@12C20000 {
"google,peach", "samsung,exynos5800", "samsung,exynos5";
config {
- google,bad-wake-gpios = <&gpio 0x56 0>; /* gpx0-6 */
+ google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
hwid = "PIT TEST A-A 7848";
lazy-init = <1>;
};
mem-manuf = "samsung";
mem-type = "ddr3";
clock-frequency = <800000000>;
- arm-frequency = <1700000000>;
+ arm-frequency = <900000000>;
};
tmu@10060000 {
spi-half-duplex;
spi-max-timeout-ms = <1100>;
spi-frame-header = <0xec>;
- ec-interrupt = <&gpio 93 1>; /* GPX1_5 */
+ ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
/*
* This describes the flash memory within the EC. Note
};
xhci@12000000 {
- samsung,vbus-gpio = <&gpio 0x40 0>; /* H00 */
+ samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
};
xhci@12400000 {
- samsung,vbus-gpio = <&gpio 0x41 0>; /* H01 */
+ samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
};
fimd@14400000 {