ARM: DRA7: Change configuration to prevent DDR reset control from EMIF
authorNishanth Menon <nm@ti.com>
Tue, 16 Jun 2015 13:29:01 +0000 (08:29 -0500)
committerTom Rini <trini@konsulko.com>
Fri, 19 Jun 2015 20:46:48 +0000 (16:46 -0400)
DRA7/AM57xx devices can be operated in many different configurations.
When the SoC is supposed to support a configuration where low power mode
state may involve the SoC completely powered off and DDR is in self
refresh, SoC EMIF controller should not be the master of the reset
signal and an external entity might be in control of things.

The default configuration of Linux on TI evms involve not powering off
the voltage rails (due to various reasons including reliability concerns)
and must not allow DDR reset to be controlled by EMIF. On platforms
where external entity might control the reset signal, this configuration
will be a "dont care".

Fixes: 536d87470869 ("ARM: DRA7: Update DDR IO registers")
Tested-by: Keerthy <j-keerthy@ti.com>
Acked-by: Brad Griffis <bgriffis@ti.com>
Signed-off-by: Nishanth Menon <nm@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
arch/arm/cpu/armv7/omap5/hw_data.c

index f1a59a3ca918e9bc7f90f8cb6983bf73af899100..3a723cace71abf353ae20038b9672c3b6c64b27d 100644 (file)
@@ -602,8 +602,8 @@ const struct ctrl_ioregs ioregs_dra7xx_es1 = {
        .ctrl_ddrio_0 = 0x00094A40,
        .ctrl_ddrio_1 = 0x04A52000,
        .ctrl_ddrio_2 = 0x84210000,
-       .ctrl_emif_sdram_config_ext = 0x0001C127,
-       .ctrl_emif_sdram_config_ext_final = 0x0001C127,
+       .ctrl_emif_sdram_config_ext = 0x0001C1A7,
+       .ctrl_emif_sdram_config_ext_final = 0x0001C1A7,
        .ctrl_ddr_ctrl_ext_0 = 0xA2000000,
 };
 
@@ -614,8 +614,8 @@ const struct ctrl_ioregs ioregs_dra72x_es1 = {
        .ctrl_ddrio_0 = 0x00094A40,
        .ctrl_ddrio_1 = 0x04A52000,
        .ctrl_ddrio_2 = 0x84210000,
-       .ctrl_emif_sdram_config_ext = 0x0001C127,
-       .ctrl_emif_sdram_config_ext_final = 0x0001C127,
+       .ctrl_emif_sdram_config_ext = 0x0001C1A7,
+       .ctrl_emif_sdram_config_ext_final = 0x0001C1A7,
        .ctrl_ddr_ctrl_ext_0 = 0xA2000000,
 };