Mention PROBLEMS in FAQ.

diff --git a/FAQ b/FAQ
index 889eb0ac43bc0322a198c86796c5225243376854..fda3323f250e478c10d1af1de842a78c14b120ed 100644 (file)
--- a/FAQ
+++ b/FAQ
@@ -49,6 +49,7 @@ OpenSSL  -  Frequently Asked Questions
 * Why does OpenBSD-i386 build fail on des-586.s with "Unimplemented segment type"?
 * Why does the OpenSSL test suite fail in sha512t on x86 CPU?
 * Why does compiler fail to compile sha512.c?
+* Test suite still fails, what to do?
 
 [PROG] Questions about programming with OpenSSL
 
@@ -655,6 +656,18 @@ the module in question. The recommendation is to disable SHA-512 by
 adding no-sha512 to ./config [or ./Configure] command line. Another
 possible alternative might be to switch to GCC.
 
+* Test suite still fails, what to do?
+
+Another common reason for failure to complete some particular test is
+simply bad code generated by a buggy component in toolchain or deficiency
+in run-time environment. There are few cases documented in PROBLEMS file,
+consult it for possible workaround before you beat the drum. Even if you
+don't find solution or even mention there, do reserve for possibility of
+a compiler bug. Compiler bugs might appear in rather bizarre ways, they
+never make sense, and tend to emerge when you least expect them. In order
+to identify one, drop optimization level, e.g. by editing CFLAG line in
+top-level Makefile, recompile and re-run the test.
+
 [PROG] ========================================================================
 
 * Is OpenSSL thread-safe?
@@ -687,10 +700,10 @@ your application must link  against the same by which OpenSSL was
 built.  If you are using MS Visual C++ (Studio) this can be changed
 by:
 
-1.  Select Settings... from the Project Menu.
-2.  Select the C/C++ Tab.
-3.  Select "Code Generation from the "Category" drop down list box
-4.  Select the Appropriate library (see table below) from the "Use
+ 1. Select Settings... from the Project Menu.
+ 2. Select the C/C++ Tab.
+ 3. Select "Code Generation from the "Category" drop down list box
+ 4. Select the Appropriate library (see table below) from the "Use
     run-time library" drop down list box.  Perform this step for both
     your debug and release versions of your application (look at the
     top left of the settings panel to change between the two)