README: mx28_common: Do not hardcode the SSP port

MX28 can boot from SSP0 or SSP1, so it is better not to hardcode the SSP port
in the instructions.

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>

diff --git a/doc/README.mx28_common b/doc/README.mx28_common
index ac824193e3cbdf9d4b8043399f07d2cb68e14184..bba2440922b80861d60fdfbcdebabf86bf402ac7 100644 (file)
--- a/doc/README.mx28_common
+++ b/doc/README.mx28_common
@@ -100,9 +100,7 @@ discussed in the following chapters.
 -----------------------------------------------------------
 
 To boot a MX28 based board from SD, set the boot mode DIP switches according
-to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=SSP0, SD/MMC master on
-SSP0, 3.3V.
-
+to i.MX28 manual chapter 12.2.1 (Table 12-2).
 
 An SD card the i.MX28 CPU can use to boot U-Boot must contain a DOS partition
 table, which in turn carries a partition of special type and which contains a