dtb-$(CONFIG_SOC_LUTON) += luton_pcb090.dtb luton_pcb091.dtb
dtb-$(CONFIG_SOC_OCELOT) += ocelot_pcb120.dtb ocelot_pcb123.dtb
dtb-$(CONFIG_SOC_JR2) += jr2_pcb110.dtb jr2_pcb111.dtb serval2_pcb112.dtb
+dtb-$(CONFIG_SOC_SERVALT) += servalt_pcb116.dtb
targets += $(dtb-y)
--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2018 Microsemi Corporation
+ */
+
+/ {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "mscc,servalt";
+
+ cpus {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ cpu@0 {
+ compatible = "mips,mips24KEc";
+ device_type = "cpu";
+ clocks = <&cpu_clk>;
+ reg = <0>;
+ };
+ };
+
+ aliases {
+ serial0 = &uart0;
+ };
+
+ cpuintc: interrupt-controller@0 {
+ #address-cells = <0>;
+ #interrupt-cells = <1>;
+ interrupt-controller;
+ compatible = "mti,cpu-interrupt-controller";
+ };
+
+ cpu_clk: cpu-clock {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <500000000>;
+ };
+
+ sys_clk: sys-clk {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <250000000>;
+ };
+
+ ahb_clk: ahb-clk {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <250000000>;
+ };
+
+ ahb {
+ compatible = "simple-bus";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x70000000 0x2000000>;
+
+ interrupt-parent = <&intc>;
+
+ cpu_ctrl: syscon@0 {
+ compatible = "mscc,servalt-cpu-syscon", "syscon";
+ reg = <0x0 0x2c>;
+ };
+
+ intc: interrupt-controller@70 {
+ compatible = "mscc,servalt-icpu-intr";
+ reg = <0x70 0x74>;
+ #interrupt-cells = <1>;
+ interrupt-controller;
+ interrupt-parent = <&cpuintc>;
+ interrupts = <2>;
+ };
+
+ uart0: serial@100000 {
+ pinctrl-0 = <&uart_pins>;
+ pinctrl-names = "default";
+ compatible = "ns16550a";
+ reg = <0x100000 0x20>;
+ interrupts = <6>;
+ clocks = <&ahb_clk>;
+ reg-io-width = <4>;
+ reg-shift = <2>;
+
+ status = "disabled";
+ };
+
+ uart2: serial@100800 {
+ pinctrl-0 = <&uart2_pins>;
+ pinctrl-names = "default";
+ compatible = "ns16550a";
+ reg = <0x100800 0x20>;
+ interrupts = <7>;
+ clocks = <&ahb_clk>;
+ reg-io-width = <4>;
+ reg-shift = <2>;
+
+ status = "disabled";
+ };
+
+ reset@1010008 {
+ compatible = "mscc,servalt-chip-reset";
+ reg = <0x1010008 0x4>;
+ };
+
+ gpio: pinctrl@1010034 {
+ compatible = "mscc,servalt-pinctrl";
+ reg = <0x1010034 0x90>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ gpio-ranges = <&gpio 0 0 36>;
+
+ sgpio_pins: sgpio-pins {
+ pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
+ function = "sio";
+ };
+
+ uart_pins: uart-pins {
+ pins = "GPIO_6", "GPIO_7";
+ function = "uart";
+ };
+
+ uart2_pins: uart2-pins {
+ pins = "GPIO_20", "GPIO_21";
+ function = "uart2";
+ };
+ };
+
+ spi0: spi-bitbang {
+ compatible = "mscc,luton-bb-spi";
+ status = "okay";
+ reg = <0x50 0x4>;
+ num-chipselects = <1>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+
+ sgpio: gpio@1010120 {
+ compatible = "mscc,ocelot-sgpio";
+ status = "disabled";
+ clocks = <&sys_clk>;
+ pinctrl-0 = <&sgpio_pins>;
+ pinctrl-names = "default";
+ reg = <0x1010120 0x100>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ gpio-ranges = <&sgpio 0 0 128>;
+ };
+ };
+};
--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2018 Microsemi Corporation
+ */
+
+/dts-v1/;
+#include "mscc,servalt.dtsi"
+
+/ {
+ model = "ServalT PCB116 Reference Board";
+ compatible = "mscc,servalt-pcb116", "mscc,servalt";
+
+ aliases {
+ spi0 = &spi0;
+ serial0 = &uart0;
+ };
+
+ chosen {
+ stdout-path = "serial0:115200n8";
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+
+ status_green {
+ label = "pcb116:green:status";
+ gpios = <&sgpio 70 0>; /* p6.2 */
+ default-state = "on";
+ };
+
+ status_red {
+ label = "pcb116:red:status";
+ gpios = <&sgpio 102 0>; /* p6.3 */
+ default-state = "off";
+ };
+ };
+};
+
+&uart0 {
+ status = "okay";
+};
+
+&spi0 {
+ status = "okay";
+ spi-flash@0 {
+ compatible = "spi-flash";
+ spi-max-frequency = <18000000>; /* input clock */
+ reg = <0>; /* CS0 */
+ spi-cs-high;
+ };
+};
+
+&sgpio {
+ status = "okay";
+ sgpio-ports = <0x0000fe7f>;
+};
--- /dev/null
+# SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+
+config SYS_VENDOR
+ default "mscc"
+
+if SOC_SERVALT
+
+config SYS_BOARD
+ default "servalt"
+
+config SYS_CONFIG_NAME
+ default "servalt"
+
+endif
--- /dev/null
+# SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+
+obj-$(CONFIG_SOC_SERVALT) := servalt.o
--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2018 Microsemi Corporation
+ */
+
+#include <common.h>
+#include <asm/io.h>
+#include <led.h>
+
+enum {
+ BOARD_TYPE_PCB116 = 0xAABBCE00,
+};
+
+int board_early_init_r(void)
+{
+ /* Prepare SPI controller to be used in master mode */
+ writel(0, BASE_CFG + ICPU_SW_MODE);
+
+ /* Address of boot parameters */
+ gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE;
+
+ /* LED setup */
+ if (IS_ENABLED(CONFIG_LED))
+ led_default_state();
+
+ return 0;
+}
+
+static void do_board_detect(void)
+{
+ gd->board_type = BOARD_TYPE_PCB116; /* ServalT */
+}
+
+#if defined(CONFIG_MULTI_DTB_FIT)
+int board_fit_config_name_match(const char *name)
+{
+ if (gd->board_type == BOARD_TYPE_PCB116 &&
+ strcmp(name, "servalt_pcb116") == 0)
+ return 0;
+ return -1;
+}
+#endif
+
+#if defined(CONFIG_DTB_RESELECT)
+int embedded_dtb_select(void)
+{
+ do_board_detect();
+ fdtdec_setup();
+
+ return 0;
+}
+#endif
--- /dev/null
+CONFIG_MIPS=y
+CONFIG_SYS_TEXT_BASE=0x40000000
+CONFIG_SYS_MALLOC_F_LEN=0x2000
+CONFIG_ARCH_MSCC=y
+CONFIG_SOC_SERVALT=y
+CONFIG_SYS_LITTLE_ENDIAN=y
+CONFIG_FIT=y
+CONFIG_BOOTDELAY=3
+CONFIG_USE_BOOTARGS=y
+CONFIG_BOOTARGS="console=ttyS0,115200"
+CONFIG_LOGLEVEL=7
+CONFIG_DISPLAY_CPUINFO=y
+CONFIG_SYS_PROMPT="servalt # "
+# CONFIG_CMD_BDI is not set
+# CONFIG_CMD_CONSOLE is not set
+# CONFIG_CMD_ELF is not set
+# CONFIG_CMD_EXPORTENV is not set
+# CONFIG_CMD_IMPORTENV is not set
+# CONFIG_CMD_CRC32 is not set
+CONFIG_CMD_MD5SUM=y
+CONFIG_CMD_MEMINFO=y
+CONFIG_CMD_MEMTEST=y
+# CONFIG_CMD_FLASH is not set
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_SF=y
+CONFIG_CMD_SPI=y
+# CONFIG_CMD_NET is not set
+CONFIG_CMD_MTDPARTS=y
+CONFIG_MTDIDS_DEFAULT="nor0=spi_flash"
+CONFIG_MTDPARTS_DEFAULT="mtdparts=spi_flash:1m(UBoot),256k(Env),256k(Env.bk)"
+# CONFIG_ISO_PARTITION is not set
+CONFIG_DEFAULT_DEVICE_TREE="servalt_pcb116"
+CONFIG_OF_LIST="servalt_pcb116"
+CONFIG_DTB_RESELECT=y
+CONFIG_MULTI_DTB_FIT=y
+CONFIG_ENV_IS_IN_SPI_FLASH=y
+CONFIG_NET_RANDOM_ETHADDR=y
+CONFIG_CLK=y
+CONFIG_DM_GPIO=y
+CONFIG_MSCC_SGPIO=y
+CONFIG_LED=y
+CONFIG_LED_GPIO=y
+CONFIG_DM_SPI_FLASH=y
+CONFIG_SPI_FLASH=y
+CONFIG_SPI_FLASH_BAR=y
+CONFIG_SPI_FLASH_GIGADEVICE=y
+CONFIG_SPI_FLASH_MACRONIX=y
+CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_WINBOND=y
+CONFIG_SPI_FLASH_MTD=y
+CONFIG_DM_ETH=y
+CONFIG_PINCTRL=y
+CONFIG_PINCONF=y
+CONFIG_DM_SERIAL=y
+CONFIG_SYS_NS16550=y
+CONFIG_SPI=y
+CONFIG_DM_SPI=y
+CONFIG_MSCC_BB_SPI=y
+CONFIG_LZMA=y
+CONFIG_XZ=y
projects / oweals / u-boot.git / commitdiff