Signed-off-by: Wolfgang Denk <wd@denx.de>
18 files changed:
0, USBOTGSS_INT_CLR);
readl(&am35x_scm_general_regs->lvl_intr_clr);
}
0, USBOTGSS_INT_CLR);
readl(&am35x_scm_general_regs->lvl_intr_clr);
}
sinclude $(obj).depend
#########################################################################
sinclude $(obj).depend
#########################################################################
extern void gpio_info(void);
#endif
extern void gpio_info(void);
#endif
void *arg);
int interrupts_init(void);
void *arg);
int interrupts_init(void);
} microblaze_timer_t;
int timer_init(void);
} microblaze_timer_t;
int timer_init(void);
sinclude $(obj).depend
#########################################################################
sinclude $(obj).depend
#########################################################################
writeb(val, BCSR_BASE + 0x04);
}
writeb(val, BCSR_BASE + 0x04);
}
popts->cs_local_opts[i].odt_wr_cfg = FSL_DDR_ODT_CS;
}
}
popts->cs_local_opts[i].odt_wr_cfg = FSL_DDR_ODT_CS;
}
}
/* Ethernet pinmux. */
configure_module_pin_mux(rmii1_pin_mux);
}
/* Ethernet pinmux. */
configure_module_pin_mux(rmii1_pin_mux);
}
- U-boot command that will write a new image to the bootloader partition in
flash.
- Linux FTD support.
- U-boot command that will write a new image to the bootloader partition in
flash.
- Linux FTD support.
#define CONFIG_ATMEL_NAND_HW_PMECC 1
#define CONFIG_PMECC_CAP 2
#define CONFIG_PMECC_SECTOR_SIZE 512
#define CONFIG_ATMEL_NAND_HW_PMECC 1
#define CONFIG_PMECC_CAP 2
#define CONFIG_PMECC_SECTOR_SIZE 512
return -EROFS;
return mtd->_block_markbad(mtd, ofs);
}
return -EROFS;
return mtd->_block_markbad(mtd, ofs);
}
{NAND_MFR_EON, "Eon"},
{0x0, "Unknown"}
};
{NAND_MFR_EON, "Eon"},
{0x0, "Unknown"}
};
sinclude $(obj).depend
#########################################################################
sinclude $(obj).depend
#########################################################################
return fdt_open_into(buf, buf, bufsize);
}
return fdt_open_into(buf, buf, bufsize);
}
return check_bytes8(start, value, bytes % 8);
}
#endif
return check_bytes8(start, value, bytes % 8);
}
#endif