U-Boot support on Raspberry Pi 4 relies on the device-tree
provided by the firmware. The blob does not contain the
U-Boot specific pre-loc-rel properties. The result is, that
the U-Boot banner is not printed.
We fix this by setting the DM_FLAG_PRE_RELOC flag in the driver,
if we rely on a device-tree provided by the firmware.
Reported-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Signed-off-by: Matthias Brugger <mbrugger@suse.com>
.priv_auto_alloc_size = sizeof(struct bcm283x_pinctrl_priv),
.ops = &bcm283x_pinctrl_ops,
.probe = bcm283x_pinctl_probe,
.priv_auto_alloc_size = sizeof(struct bcm283x_pinctrl_priv),
.ops = &bcm283x_pinctrl_ops,
.probe = bcm283x_pinctl_probe,
-#if !CONFIG_IS_ENABLED(OF_CONTROL)
+#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
.flags = DM_FLAG_PRE_RELOC,
#endif
};
.flags = DM_FLAG_PRE_RELOC,
#endif
};
.platdata_auto_alloc_size = sizeof(struct bcm283x_mu_serial_platdata),
.probe = bcm283x_mu_serial_probe,
.ops = &bcm283x_mu_serial_ops,
.platdata_auto_alloc_size = sizeof(struct bcm283x_mu_serial_platdata),
.probe = bcm283x_mu_serial_probe,
.ops = &bcm283x_mu_serial_ops,
-#if !CONFIG_IS_ENABLED(OF_CONTROL)
+#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
.flags = DM_FLAG_PRE_RELOC,
#endif
.priv_auto_alloc_size = sizeof(struct bcm283x_mu_priv),
.flags = DM_FLAG_PRE_RELOC,
#endif
.priv_auto_alloc_size = sizeof(struct bcm283x_mu_priv),
.platdata_auto_alloc_size = sizeof(struct pl01x_serial_platdata),
.probe = pl01x_serial_probe,
.ops = &bcm283x_pl011_serial_ops,
.platdata_auto_alloc_size = sizeof(struct pl01x_serial_platdata),
.probe = pl01x_serial_probe,
.ops = &bcm283x_pl011_serial_ops,
-#if !CONFIG_IS_ENABLED(OF_CONTROL)
+#if !CONFIG_IS_ENABLED(OF_CONTROL) || CONFIG_IS_ENABLED(OF_BOARD)
.flags = DM_FLAG_PRE_RELOC,
#endif
.priv_auto_alloc_size = sizeof(struct pl01x_priv),
.flags = DM_FLAG_PRE_RELOC,
#endif
.priv_auto_alloc_size = sizeof(struct pl01x_priv),