X-Git-Url: https://git.librecmc.org/?a=blobdiff_plain;f=include%2Fns16550.h;h=18c9077755bef823f388c8219d0bdc3de8fd86ee;hb=406df85345f942d9348443983d81a01e013e920b;hp=1311f4cb919e3dff6917a593fb390671613f5795;hpb=55926ddd189546742a4496e6690c2b62958cd7cd;p=oweals%2Fu-boot.git

diff --git a/include/ns16550.h b/include/ns16550.h
index 1311f4cb91..18c9077755 100644
--- a/include/ns16550.h
+++ b/include/ns16550.h
@@ -31,6 +31,9 @@
 #define CONFIG_SYS_NS16550_REG_SIZE (-1)
 #endif
 
+#ifdef CONFIG_NS16550_DYNAMIC
+#define UART_REG(x)	unsigned char x
+#else
 #if !defined(CONFIG_SYS_NS16550_REG_SIZE) || (CONFIG_SYS_NS16550_REG_SIZE == 0)
 #error "Please define NS16550 registers size."
 #elif defined(CONFIG_SYS_NS16550_MEM32) && !defined(CONFIG_DM_SERIAL)
@@ -44,19 +47,37 @@
 	unsigned char x;						\
 	unsigned char postpad_##x[-CONFIG_SYS_NS16550_REG_SIZE - 1];
 #endif
+#endif /* CONFIG_NS16550_DYNAMIC */
+
+enum ns16550_flags {
+	NS16550_FLAG_IO		= 1 << 0, /* Use I/O access (else mem-mapped) */
+	NS16550_FLAG_ENDIAN	= 1 << 1, /* Use out_le/be_32() */
+	NS16550_FLAG_BE		= 1 << 2, /* Big-endian access (else little) */
+};
 
 /**
  * struct ns16550_platdata - information about a NS16550 port
  *
  * @base:		Base register address
+ * @reg_width:		IO accesses size of registers (in bytes, 1 or 4)
  * @reg_shift:		Shift size of registers (0=byte, 1=16bit, 2=32bit...)
+ * @reg_offset:		Offset to start of registers (normally 0)
  * @clock:		UART base clock speed in Hz
+ * @fcr:		Offset of FCR register (normally UART_FCR_DEFVAL)
+ * @flags:		A few flags (enum ns16550_flags)
+ * @bdf:		PCI slot/function (pci_dev_t)
  */
 struct ns16550_platdata {
 	unsigned long base;
+	int reg_width;
 	int reg_shift;
-	int clock;
 	int reg_offset;
+	int clock;
+	u32 fcr;
+	int flags;
+#if defined(CONFIG_PCI) && defined(CONFIG_SPL)
+	int bdf;
+#endif
 };
 
 struct udevice;
@@ -117,6 +138,14 @@ typedef struct NS16550 *NS16550_t;
 #define UART_FCR_RXSR		0x02 /* Receiver soft reset */
 #define UART_FCR_TXSR		0x04 /* Transmitter soft reset */
 
+/* Ingenic JZ47xx specific UART-enable bit. */
+#define UART_FCR_UME		0x10
+
+/* Clear & enable FIFOs */
+#define UART_FCR_DEFVAL (UART_FCR_FIFO_EN | \
+			UART_FCR_RXSR |	\
+			UART_FCR_TXSR)
+
 /*
  * These are the definitions for the Modem Control Register
  */